Top 20 Crosley CAWC529JQ Top Load Washer Questions & Answers

maybe bad thermal fuse

It is possible that the machine does not start off the cycle because there are errors due to feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven starting from the flow of water into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect. If the water flows though the inlet then the flow pressure should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor for rinse and wash. Test a pressure switch: Click on : http://www.youtube.com/watch?v=HZZ2bDMspj8 Check this link to replace the inlet valve: http://www.espares.co.uk/advice/washing-machines/a/7/1408/how-to-replace-the-inlet-valve-on-a-washer-dr.html

Sorry not familiar with this model

Likely possibilities:

1. Coupling between motor and transmission has broken.
2. Transmission has failed.

Number 1 is cheap and relatively simple to replace. Tip the machine up in front and place a support under the front edge of the cabinet. Look for broken pieces on the floor. See if you can freely rotate the motor shaft without affecting the transmission shaft. Check that the transmission shaft can be turned by hand. If yes to both, replace the coupling. If it breaks again after a short time, transmission is likely bad Number 2 is expensive and difficult. If the coupling's not broken and the motor is operational, OR the coupling breaks again after only a short time, then replace the transmission, or the whole machine entirely.

The machine thinks the door isn't closed. Could be due to a faulty door switch or control board.

check back of unit as the concrete on the back may of been dislodged check not over loaded also the belt maybe loose or streached

dont interrupt it. if it is an older machine it may not have the capability to pick up where it left off

there are 2 screws holding it in place you can undue them and pull it out from between the tub and top of washer then splice the switch in. MAKE SURE YOU UNPLUG IT FIRST Go to sears web site and you can see the break down on parts

there is a clutch coupler that has probably gone bad

check the knob it is probably broken

sounds like a bad transmission

Clutch is only used locking into spinout. Is drive coupling is loose or torn, if not you are most likely talking about a bad transmission

My lidlock is broke, is there any way to bypass that so washer will work?

look to see where the drain hose is and the water levelif the hose is lower than the level of the wateryou are siphoning this will happen in the permanant press cycle

Open the panel and. Check for leak in the pump

It will take more than one hour

uplug power. remove switch, then tape the wires together. this will make a complete curcuit, so it should run. good-day !

need a replacement plug where can I find one

If you dissolve the detergent in a bucket of water before adding it to the clothes you wont get this problem.

Good day Mr.Wesley Smith... I have instruction guide on how to replace transmission and safety precaution when you do that..But unfortunately that files is have a larger size that can't send it to this tread..So I need your yahoomail address to send attachment..This attachments files compose of picture so you can easily follow the instruction given..Please reply to this tread with your yahoomail add..I will wait for your immediate response...Please reply only with this tread with your email address..Thank you