20 Most Recent Crosley CAWC529JQ Top Load Washer - Page 2 Questions & Answers

need a replacement plug where can I find one

Clutch is only used locking into spinout. Is drive coupling is loose or torn, if not you are most likely talking about a bad transmission

Your spin cycle control seems to be bad. This is also called your timer. Check for power supply by pulling off your top panel and checking for power everywhere.

My lidlock is broke, is there any way to bypass that so washer will work?

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing Machine not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101

look to see where the drain hose is and the water levelif the hose is lower than the level of the wateryou are siphoning this will happen in the permanant press cycle

It will take more than one hour

Open the panel and. Check for leak in the pump

Good day Mr.Wesley Smith... I have instruction guide on how to replace transmission and safety precaution when you do that..But unfortunately that files is have a larger size that can't send it to this tread..So I need your yahoomail address to send attachment..This attachments files compose of picture so you can easily follow the instruction given..Please reply to this tread with your yahoomail add..I will wait for your immediate response...Please reply only with this tread with your email address..Thank you

If you dissolve the detergent in a bucket of water before adding it to the clothes you wont get this problem.

my belt broke from my crosley machine how can i fix it

This is a vertical modular washer.
If you have items stuck between tubs or something in the pump that could possibly be the problem. The washer is fairly new to the market . Use the service manual I provided to diagnose the problem and report back to me would you? It could be helpful to a bunch of folk. If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hello & Welcome to FixYa

You can check if the lid switch is fine, you can jump start the lid switch by connecting both the wires with each other or use the third wire to act as jumper between the two. After this if the problem is solved then replacing lid switch is recommended repair. If that is fine then replace the control board as that is bad and needs replacement. Please get back to me if you have any other questions.

Kevin