20 Most Recent Euro-Pro Steam Generator EP8001 Iron - Page 3 Questions & Answers

i have use and care instructional manual for the EP8010 if this helps anyone

There is a water level indicator and you must use according to the amount of ironing you have in mine. If there is a whole lot fillit up to the full limit mark , if less use less just for an emergency.
Hope you get this right. Good day

I have the same problem. How did you solve it?

Hi,
Try using different water...

Here is a tip that will help you with that problem...

My Steam Iron is Leaking Water
http://www.fixya.com/support/r5301301-steam_iron_leaking_water

heatman101

Hi,

Here is a tip that will help you to troubleshoot your iron and figure out what is wrong with it.

Electric Iron not Heating Up or not Working Right
http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not

heatman101

Hi,

Kindly mention the Model Number so that i could try to Find out the Instruction's Guide.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

try yellow pages.com under small appliance repair i think you enter your zip code for your area

Hi.
Parts for this steamer are not longer available.
If the steamer does not heat enough, and it is very slow heating, then you can still try fixing the problem by descaling the steamer several times. Scale accumulating on the heating element may reduce heating causing this problem. If problem is scale, then the steamer had gone worsening in time.
If the fault appeared suddenly, then it is not scale. In that case it is the heating element or the thermostat.
Parts in that case must be taken out and tested using a multimeter on impedance, to read if the parts circuit is open (faulty).
The difficult part of the repair will be finding a compatible part, best thing to do is asking to a local small appliance retailer with part in hand.
Other solution is buying a new steam generator. If you want Europro, you can get a G6200 from $99 (RRP $150).
Regards.

unplug and toss. replace. has a short somewhere in unit. better safe than sorry!! if still under warranty- get it replaced!
good luck- stay safe!

Return it to the purchaser and they will replace it or return to the manufacturer. Be sure to take your reciept with you

Depends on cost of new engine, generator, and engine repairs. Personally, I would look at northerntool.com as well as harborfreight.com to find a replacement. Both have retail locations, might be one nearby and you can save the shipping charge.

your thermostats should be changed

there is most likely a small port where some particles have clogged...fill reservoir with vinegar and water (50/50) and allow to soak 24 hrs, then reheat then shake vigorously to drain then rinse then retry

I'm having a problem with a Euro Pro Steam Iron as well. Thier customer service phone number is 1-800-798-7398. Hope this helps

I have the same problem and was wondering if you found a solution?

you will have to contact the service center.as this part is not made by any other.

www.ukwhitegoods.co.uk/modules

www.elecdir.com

www.thermis-sa.gr/english/details