20 Most Recent
Riccar 8850 Vacuum - Page 6 Questions & Answers
How can I replace the belt on a Riccar Rad 8 model
Your belt should not need replaced unless it has over heated the belt somehow. It has a lifetime belt. There are screws on the bottom of the vacuum that allow the cover of the nozzle assembly to be removed to gain access to the belt area. It may be less cost in the long run to have it looked at by a Riccar repair technician.
Replace belt on Riccar Brilliance
The Brilliance has a lifetime belt but if it gets overheated it can get warped and comes off. Normally you do not need to replace the belt unless there is a problem. You have to remove the cover over the power nozzle assembly by removing the screws on the bottom. Notice how the belt goes around the motor shaft and through the "Hall Assembly" which is the spring loaded lever that detects a jam and shuts the brush roll motor off.
N2000 clean filter
The red guard goes on top of the foam after it is installed. The purpose of the red guard is to keep the bag from sucking down against the filter when you get a few inches of dirt in the bottom of the bag. If it sucks down against the filter the dirt in the bag will cause an airlfow restriction even though the bag is not full.
Blue light
Depending on the model, it may mean it's time for a filter change.;
I can't reset my thermal reset button on my Riccar Brilliance
You may have hair and debris in the endcaps or bearings of your brushroll causing a restriction. The belt sensor thinks you have something stuck in the brushroll so it shuts it off. It's a simple fix, if you can't figure out how to do it take it to your Riccar dealer.
How to replace Simplicity vac brush roll strips?
The caps will come out of the end of the metal roller. They can be difficult if it's been a long time as dirt and grime can build up. Try sticking a flat head screwdriver in and gently twisting to get the caps to slide out.
How do I change the fan in my riccar vacummn?
It depends on which model you have. Most models have a fan that will never need replaced. Tandem air and Supralight models have a fan that could be damaged on older models but is unlikely on newer models as fan are now made from a flexible material. Remove the motor assembly and disassemble to get to the fan. Remove the nut from. The shaft and remove the fan. Install new fan and put back together in reverse order as it was taken apart.
How do I change a riccar vacuum bag type z
Attach the bag securely in the bag holder. Slide the bag holder into the groove in the vacuum making sure the hole in the bag lines up with the hole in the vacuum where the hose attaches to.
RICCAR 220 CANISTER VACCUM CLEANER POWER HEAD FALLS OFF OF WAND.
There is a little tab that releases when you push the pedal. The tab is probably worn and needs to be replaced. This repair is not hard to do when you know how but can be difficult if you've never done it. You can get the parts and advise from your local Riccar dealer
How do I replace Riccar 8625 upper cord hook?
There are various small parts that make up the hook. First insert the L bolt through hole in handle. Put cord holder on L bolt, put lock washer and nut on and tighten nut. Then put cord hook on L bolt followed by spring, large washer, lock nut and another nut. Snug nut up and test to be sure it will swivel.
Not finding what you are looking for?