Whirlpool GSS30C6EYW 30 cu. ft. Side-by-Side Refrigerator with Tap Tou - Page 2 - Answered Questions & Fixed issues

these units has a bad mother boards. I’m happy to assist further over the phone at https://www.6ya.com/expert/james_1cb31da1bc8c6102

Is the ice bucket still full? Ice makers have built in mechanism to cut itself off when ice bucket is full.

The thermostat may be stuck froze in open position, in off and not closing, calling to replace the thermostat or the defrost timer

Sahal_laher, We would like to inquire further about your post with you. Please respond back to this email address [email protected] with your name, user id (Sahal_laher), phone number, street address, zip code, reviewer name, model & serial number, and date of purchase on the appliance.

We are sorry to hear of the problem with your Whirlpool appliance. We would recommend having a local certified technician in your area properly diagnose and repair the issue you are experiencing. Please email us at [email protected] and provide your full name, phone number, address and the model and serial number for your freezer.

control board issue or loose wire

lucky to get five years out of any white good time to do the math replacement cost of failed components verses benefits of a new up-right Freezer

This is a super freeze button, it is for when you get a lot of frozen food and put it in you can push the super freeze button and it bypasses the thermostat and runs the freezer constant to freeze the food quicker.

I hate the hassle too, but take or send it back to where you got it. It simply shouldn't fail that quickly!

The 19 in the model is the cubic ft capacity of that freezer. I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

I have a whirlpool WVG301 freezer and have just had a similar problem with my freezer not freezing and all my food spoiling. Open the plastic cover at the top front above the door. In side is a timer which controls the automatic defrost mechanism. On top of this timer is an adjuster. This timer seemed to get jammed. Give it a slight turn with a screw driver and your compressor might just kick in and work again like mine did!!! Hope this helps?

Hi, you have a common problem with your control boards; there is a cheap fix if you can use a soldering iron or you can have your modules repaired.
Let me know

bb

Seal needs to be replaced around door. Make sure magnetic strip is tight against sides of refrigerator, even if you have to cut the outside so it lays flat against the sides.

a refrigerant line may have been damaged in the move, loss of refrigerant or a kinked line has stopped the compressor from working, need to attach refrigerant gages to find the problem and know the refrigerant level

there are 3 problems I've come across with water leaks on this model. if there is ice build up on the back of the freeze it could be a drain problem or if its around the ice maker it could be that the supply tube is too long. also watch out if you push the unit too far back against the wall the gray water supply line could snap off ( replaced 6 of these)

Without looking at it it's hard to say for certain, but most likely it's low on freon. It could also be a defrost heater not working properly.

What is the question?

If there is an ice maker in the freezer, look to see if the water is coming from there. If it is then replace the solenoid valve where the water comes into the back of the refrigerator.

Take the SEAL and put it in a BATHTUB with HOT HOT WATER.... It is become very flexible. Dry it off well and attach it. You may need to use a hair dryer to deal with small defects in the seal, but patience will pay off well in this repair. kindy, Jim

sounds like a gas problem. either gas has leaked out, or there is a block in the pipes. this will need a technician to fix.