Top 20
Whirlpool GSS30C6EYW 30 cu. ft. Side-by-Side Refrigerator with Tap Tou - Page 9 Questions & Answers
Whirlpool mod.ev200nxan auto defrost does not
Is the freezer fan working ? If not , pt # 4357004 . If it is working , then compressor is bad . One of the internal valves are bad . Non repairable unless compressor is replaced (too much money ) .
8/25/2009 5:58:40 PM •
Whirlpool...
•
134 views • 0 helpful votes
After power cut the temperature of the fridge and
It means the compartment temperatures are increased then allowed limit.Generally in some appliances the maximum temperature is indicated at the display with an alarm after the electric cutoff.If the temp is high in the compartments
6/29/2009 7:12:49 PM •
Whirlpool...
•
606 views • 0 helpful votes
Sometimes water comes out everywhere all over the
behind the freezer inner wall is a tube that leads down to a pan under your refrigerator it is blocked: remove the wall; remove the ice buildup on the evaporator coils then using a funnel pour hot water through the tube to the pan. be sure to empty the pan when you are done
9/5/2009 2:46:59 AM •
Whirlpool...
•
90 views • 0 helpful votes
Water not getting to the ice maker
Either the water valve that opens when the ice maker calls for water (located in the back of the fridge at the bottom) went bad or is leaking and the fill tube to the ice maker gets clogh with frozen water and when it calls for water won't get through, in both cases you need to replace the valve.
8/12/2009 8:09:56 PM •
Whirlpool...
•
125 views • 0 helpful votes
My whirlpool ice maker makes a noise like its growling or like a
please switch off your refrigerator for at least 8 hrs. than again switch it on. if your problem is not cured than it is sure that your refrigerator have the blower problem because for this reason only, the problem arrises ....... please visit your service authority...........have a nice day:-)
5/15/2009 3:57:36 AM •
Whirlpool...
•
1,199 views • 0 helpful votes
My Whirlpool Model ED5FHEXNS01 is 4 years old and
Where you dissconnected the water line is not a pump but it is a solonoid valve just like the inlet on your washing machine and the plastic coil has probably gone bung. take it off and have it tested for continuity if it,s open circuit you.ve found your problem,if so replace it. Hope this helps. Kind Regards Stefan.
7/7/2009 8:58:15 AM •
Whirlpool...
•
208 views • 0 helpful votes
Ice maker only fills the tray partially.
There is an adjustment, but first check your filters, including the one in the inlet of the control valve. To find the adjustment, take the cover off the front of the ice maker. On the side may be a little hole. Look for any 'increase' arrow or such. If not, use a small screwdriver to turn the adjustment a half turn and let it make a load of ice. If it gets smaller, go the other way, use small adjustments. If you can get the owner's manual, it will help a lot. Google your unit for one, you may be able to get it downloaded free from Whirlpool.
5/5/2009 2:16:48 AM •
Whirlpool...
•
1,233 views • 1 helpful votes
My Whirlpool E-State Refrigerator not defrosting
check out the defrost timer beside the compressor.if its not spinning properly or if spinning but very slowly.then its the timer problem that is creating this problem.
the cost of new timer is near to $45.and you can get it at
www.repairclinic.com
thanks.
7/9/2009 2:05:20 PM •
Whirlpool...
•
138 views • 0 helpful votes
Whirlpool French Door Freezer on the bottom not
You have a dfrost problem if at all possible remove food from refrigerator and unplug it, leave the doors open. By morning the freezer should be defrosted and that will buy you time to fix or call someone. defrosting can be quickened with use of a hair dryer. This is only a TEMPORARY fix and freezer will need to be defrosted again after 4-5 days.
6/18/2009 1:34:32 AM •
Whirlpool...
•
178 views • 0 helpful votes
Ice build up
You should to check the Whirlpool Gladiator Freezerator's door sealer to make sure all rubber or plastic seal very well to prevent air humidity come in to build up frost fast. Also, you have to defrost completely and wipe with cloth or paper towel to absorb all waters out and let it dry completely to prevent frost build up.
5/8/2009 12:01:36 AM •
Whirlpool...
•
463 views • 0 helpful votes
Thin Ice on Whirpool Ice Maker
Hi
If
The ice maker has completely stopped producing ice
Check to see whether the ice maker has been turned off. Here's how to check. Look for a wire along the right side of the ice maker that looks a bit like a coat hanger. If this wire is in the raised position, the ice maker is turned off. On some units you simply lower the wire to the down position to turn the ice maker on. On others, you lower a small red plastic lever to lower the wire. If the wire is in the proper position check the freezer temperature, it should be between 0-8 degrees Fahranheit. If it is warmer than 10-12 degrees, the ice maker may not produce any ice. Check your door seals and thermostat, repair/replace as necessary.
The ice maker is producing ice poorly
When an ice maker is producing ice poorly--when it produces just a few cubes or none, or when the cubes are too small--it's usually because of a clogged water line or a defective water inlet valve.
First, check the water line attached to the back of the refrigerator for good water flow. To do that, first turn off the water supply valve. Then remove the water line from the back of the refrigerator. Next, place the water line into a bucket and momentarily turn the water valve back on to test the flow. If the flow is poor, you need to repair, clean, or replace the tubing or the shut-off valve that supplies the water. If the flow is good, you may have to replace the water inlet valve.
Please do rate the solution as "FixYa" if found useful and revert for further assistance.
Thanks
Rylee
4/5/2009 9:10:22 PM •
Whirlpool...
•
754 views • 3 helpful votes
Whirlpool american fridge freezer danger alarm
This issue seems to be of gas leak. The gas keeps both fridge & freezer cold. When the gas is gone then neither will chill. If you continue to run the compressor motor with no gas in the system you may damage it. The hole in the pipe may be repairable and then the gas can be refilled. Depends on the overall age & condition of the appliance as to repair or buy another. Only you can decide.
Let me know if you need further assistance
Thanks
Kinldy rate the answer.
Keivn
4/29/2009 3:03:00 PM •
Whirlpool...
•
269 views • 0 helpful votes
Freezer runs for 24 hours then melts
The defrost timer is going bad. It should go into defrost mode once every 24 hours but it shouldn't allow things to melt. It isn't picking back up. Relatively cheap.
6/4/2009 2:50:39 PM •
Whirlpool...
•
96 views • 1 helpful votes
Not finding what you are looking for?