20 Most Recent
Jet Tech Systems F-14 - Multi-Purpose Ware Washer, Compact Counter " - Page 6 Questions & Answers
BabyLock Solaris needle plate will not close
If the needle plate on your BabyLock Solaris sewing machine is not closing or latching properly, there are a few possible reasons for this issue:
- Incorrect installation: Double-check that you have installed the needle plate correctly. Ensure that it is aligned properly with the machine and that all the mounting screws or clips are securely fastened. If the needle plate is even slightly misaligned, it may not close or latch properly.
- Debris or obstruction: It's possible that there is debris or an obstruction preventing the needle plate from closing. Take a close look at the needle plate area and remove any lint, thread, or other debris that may have accumulated. Use a small brush or compressed air to clean the area thoroughly.
- Damaged or bent needle plate: Examine the needle plate for any signs of damage or bending. If the needle plate is warped or bent, it may not align properly with the machine, preventing it from closing correctly. In such cases, replacing the needle plate with a new one is recommended.
- Mechanical issue: If the problem persists even after trying a new needle plate and ensuring correct installation, there may be an underlying mechanical issue with the sewing machine. It could be a problem with the latch mechanism or another component that requires professional attention. In such cases, it's best to contact BabyLock customer support or take the machine to an authorized BabyLock service center for further diagnosis and repair.
Always follow the manufacturer's instructions and safety guidelines when working with sewing machines and their components. If you are unsure or uncomfortable performing any troubleshooting steps, it's best to seek professional assistance to avoid further damage to the machine.
6/18/2023 7:34:23 AM •
Dishwashers
•
Answered
on Jun 18, 2023
Home Health Care
Home care assistants serve an honorable and crucial role in our society by helping the disabled, elderly and chronically ill maintain high quality of life. These caretakers understand the dignity and happiness that come from proper hygiene, cleanliness and nutrition, as well as everyday activities and recreations that we often take for granted.
HomeCentris Healthcare Empowering people to remain in the community...
6/15/2023 5:15:19 PM •
Dishwashers
•
Answered
on Jun 15, 2023
I need to replace the
asko is a hard one to get generic parts for,, if you will have any luck repair clinic.com will be your best bet
5/22/2023 10:52:03 PM •
Dishwashers
•
Answered
on May 22, 2023
Door spring change
Hi, THe door springs are located behind the lower kick plate. Just remove the four screws that hold the panle on and you will see the springs and cables that help hold the door up.
Please let me know if I can assist you further.
Vic
5/18/2023 10:04:14 PM •
Dishwashers
•
Answered
on May 18, 2023
What is causing the drain pump to continue running
C1 - Partially Blocked Drain - This error will occur when dishwasher was unable to pump out water in less than 95 seconds. Check drain line for debris and blockage. If clear, check for a restricted drain valve in the pump. Check the pressure sensor for correct operation as it sounds like it may be defective and thinks that the machine is still full of water after it has emptied.
5/16/2023 10:51:10 AM •
Dishwashers
•
Answered
on May 16, 2023
Not finding what you are looking for?