20 Most Recent Garmin Gmr 41 Marine Radar For Gpsmap 3200 Series Questions & Answers

All transducers should read 0 ohms or close to it. If not you most likely have a broken pin in the connector or wire.

I can't remember correct setup but make sure that box is powered and connected to GPS in right input. With no power to box it won't be discovered by head unit.

Place your ear against the transducer with unit ON. You should hear it 'tikking' ( tic tic tic ) then the transducer is ok...

garmin_products_out_of_support_list_20140207 Here is a pdf for Garmin. you should be able to contact them though email. Good luck

https://www.garmin.com/en-US

Check you transducer cable route and connections. Look for kinks, punctures, & tears in cable. Visually check the transducer for damage. #2 check the units operation on a friends boat with the same set or research a local marine repair shop to check ops. Best of luck on the problem.

Hi You'll need to identify and connect NMEA out (+ and -) from your 451 to NMEA in (+ and -) to your VHF to get it done. Hope this is helpful. -Steve

Hi Tom! I believe I'd start troubleshooting with the power supply. Disconnect and clean the cable ends with Fluid Film (I swear by this stuff) Check the crimps and make sure they're not loose. Pay special attention to the ground connection. With your temp not reading correctly in addition to your depth rolling, this usually indicates a common fault. (Usually ground.) Check the data cable and socket on the control head for corrosion (again, Fluid Film is your friend) If that doesn't fix your problem, then a "hard boot" or reset of your system might solve the problem(s). Hope this helps you out. Good Luck! -Steve

Hi James! According to the owner's manual, the 451 can be used as a fishfinder when connected to a transducer. I would contact Garmin directly to see if the ducer from your 160c is compatible with a 451. If it is, you're in business! You'll likely have to cut/splice cable, but it'd be far easier than replacing the thru-hulls. (The 451 does come with transducers.) It has been my experience that Garmin is REAL good when it comes to answering questions from consumers. Good luck! http://www.garmin.com/us/support/

we had replaced the engine in our 87 4.3 star craft and when we put the omc cobra stern drive back in we now dont have foward gear, we have nuetral and reverse. could it be the linkage or could it be the shifter cable or any other idea's that could be the problem.