20 Most Recent
Imperial IFS40 Deep Fryer - Page 4 Questions & Answers
How do I test the Pitco Frialator 35CS high limit switch
remove connections from hi-limit switch, and put an ohm-meter across connections then heat it with a match or heat source of that temp range,heat the face and watch your meter it will show open when hi limit reaches cutoff limit/if you need exact cutout temp,you will need to have one of those digital read-out temp gun
How can i check if its a bad themopile or gas walve
In my experience, the thermocouple (you called it a thermopile) is usually the weak link that fails, and is also the least expensive to replace, so start there with a high degree of confidence. The purpose of a thermocouple is to convert the heat of the pilot flame into millivolts of electricity, which holds the pilot gas valve open, assuring that there is a flame present if there is gas flowing. They typically cost around $20.Here is the website for the manufacturer, which includes the manual download and contact information:http://www.imperialrange.com/
How u go about increasing thermostat when recalibrating
Hi there!Using a precision screw driver, turn the thermostat calibration screw counter clockwise to increase the temperature cut-in of the thermostat, it is about 5 degrees celcius per 1/8 turn of the calibration screw.Regards.
How to test thermopile on Imperial IFS-40 deep fryer
Hi there.
You will be needing a dc voltmeter set at millivolt to test a thermopile.
measure the voltage across the termials of the thermopile when it is heated by the pilot flame, you should have 600 to 750 millivolt reading.
If the reading is less than 600, try cleaning it with non metal scrubbing pad and/ or try increaing the pilot flame or you have to replace it with a new one.Try the same with your other fryers with thermopile.
You will be able to find parts at
http://www.imperialrange.com
Regards.
Pilot light wont stay lighted
Hi there.Try cleaning the thermopile (cylindrical piece of metal behind the pilot) wwith a non-metal scrubbing pad. thermopile needs the heat of pilot flame to keep the pilot flame lighted as well as burners during operation.Kindly check also if the gas has sufficient pressure.Regards.
Not finding what you are looking for?