JBL MCDC100 6-Disc CD Changer - Answered Questions & Fixed issues

Everyone keeps talking about a reset small hole around eject button/ power switch. I have the JBL 6 disc changer. Where is this reset hole on that system? 2002 Camry.

I've had this happen before with car stereo's uh i just normally unscrew the screws out of the top of the player to where you can get to the tray or slot for the cds and force the cd tray or the cd itself out but be careful and not break the cd this might work it usually does for me

try blowing it all out with a air gun there may be some dirt on the inside. you may also want to try a cd cleaner

try disconnecting power to the radio for an hour or so. usually it is best to disconnect the battery overnight to reset the microprocessors.

Was the battery terminal taken off?

Welcome to Fixya

Try to use cd cleaner first to clean the lens. Its giving you a BAD CD error because the lens cannot read the disc. Do the cleaning method 2 times.

Please reply to this email for any update.

Thank yuo for using Fixya! If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

as you said the cd is stuck and the tray is not comming outswitch off you system wait for few seconds then switch on the system and press eject take big needle or streighten the papper clip and you will find a small hole below the tray insert the needle and push it not hard burt hard the system tray will eject if still the tray is not comming out power off the system remove the cover by removing the screw after removing the screw u can see the cd remove the plug them and see if the cd tray comes out on not

Have you tried putting the CDs in label-side down? My Alpine needs them to be label-side-up, but a friends changer (kenwood? I don't remember) needs them to be label-side-down.

Whichever way you've put them, try flipping the CDs to see if it makes a difference.

I have the same problem. Any luck?

Take it to any local car audio shop, find out the make of the changer and chances are good that it can be fixed quickly and at a minimal cost or replaced with an aftermarket unit that will work perfectly with the factory radio for under 600 installed easily. Hope this helps

HI.. CD CLEANERS DONT WORK....IF YOU HAVE THE TIME.. REMOVE THE WHOLE UNIT OUT..AND CLEAN THE LASER...(Q-TIP,CLEANER)IF YOU THINK IT MAY JUST BE A DIRTY LASER IT'S SOMETHING TO TRY.. BEFORE GETTING A NEW ONE ..WITH OUT LOOKING AT IT IS HARD TO SAY.. CHECK ALL CONNECTIONS ALSO.. GOOD LUCK

need to know what year and model of land cruser

Could be a bad ground i wish u lived around me I run my own audio installation business

It sounds like you have a disc stuck and it's overriding any commands. I would put the key to acc. Then I would unplug the cd changer from the back of changer and after a min or 2 plug it back in as you hold down on the eject button

Page 168 of the manual onwards.

2008 Toyota Solara Owners Manual and Warranty - Toyota ...

www.toyota.com > owners > resources > solara > 2008

Find everything you need to know about your 2008 Toyota Solara in the owners manual from Toyota Owners. ..

No user serviceable parts! If not working just replace!

YOU MAY HAVE TO GOING THE MENU AND CHECK THE REAR SEAT SETUP

Bad or shorted voice coil on sub maybe. If you have two subs try them one at a time to see if it goes into protect mode. Whatever sub does it is bad.

It is very dependent on your vehicle and whether you are using the built-in amp of the head unit or a separate amp. Ideally, I would recommend a good 6.5" component set.

Having them wired in series. Should only be a ground issue.