Top 20 Stoves 720EF Electric Double Oven Questions & Answers

Hello, Kimquy25 - Fixya.com is not a website for scheduling a Sears technician to inspect your gas stove. Since you live in Houston, Texas, see the information here: https://www.searshomeservices.com/locations/appliance-repair/tx-houston/4201-main-st Personal opinion: If you can avoid it, do not use your gas stove / oven until a repair person checks it. Also, if you think there is a gas leak, IMMEDIATELY LEAVE YOUR HOME, go to a safe location and call the CenterPoint Energy natural gas Leak Emergency Hotline: 888-876-5786. - See more at: http://www.centerpointenergy.com/en-us/residential/customer-service/reporting?sa=LA#sthash.fGZo7JXh.dpuf Best wishes.

You must remove the cabinet from around the ovens to access the parts.

should be able to have on manual as for normal cooking

The timer IC oscillator is not working, you my need to replace the board.

Hi, for the top oven: Actual capacity 39 litres, Usable capacity 35 litres. for bottom oven: Actual capacity 59 litres, Usable capacity 50 litres.

I would suggest the wrong wires were cut off and joined. If the ground wire touches the power wire a fuse or circuit breaker will blow.. Before you do anything more make sure the curcuit breaker is not blown. If it is reset it and turn the cooker back on. If the breaker blows again then it is wired wrong.

Try taking the power wire that goes into the timer and the power wire that comes out of the timer and put them together not hooked to the timer and that should work. If that works you should solder them together and electrical tape them good. Make sure the power is off when you do this so you don't cook yourself.

Yes you can, your best bet. Try to go to manufacture of your stove.
If they discontinued then try the web

YOU NEED A NEW CONTROL MODULE, THAT PANEL IS A COMPUTER BOARD AND DOES BREAK. EITHER FROM HEAT EXPOSURE OR CLEANING SOLVENTS

Join the orange to the red wire, and then join the brown to the white wire. I have done that and everything is working perfectly (except of course the pre-programming which the clock would do).

Look for any burned or discoloration on the bottom bake element. Did you try the broil on the lower oven? If neither is working you may have a board or touchpad issue.

It is very possible the control board is going bad. Before replaceing the control board pull the connectors and reinstall them. There could be a bad connection causing the display not to lioght up completly. If that doesn't work then it looks like control board time.

WIRING WHEN POWER WAS ON, OR PUTING HOT WIRE TO GROUND, A POWER SURGE WILL DO THAT

I don't think that the lights are repairable,it looks to me that they are part of the timer display and if this is the case it would not really be a diy job.

Ask the internet, or contact the manufacturer.

When you replaced the burnt out selector did you notice any other damage? The selector switch may be connected to the energy input control. Most circuits have some sort of control, allowing only the right amount of energy to be put in. If this got damaged, the fuse would be inconsistent. Elisa Jed ' http://www.atlasappliances.com

there are no fuses on ovens other than soldered into PCB's or timers. they use the household RCD