20 Most Recent Mad Catz PS3 Bluetooth® Headset Wireless Headset - Page 9 Questions & Answers

Pass key is 0000(four zeroes)

forget pass key for madcatz

when you buy it for the 1st time, charge it up for double the reckemended 1st charge

did you already pair the device to the ps3? usually the security code is 0000.

MY FRIEND WAS JUST HAVING THAT PROBLEM WITH BAD COMPANY ALSO 2 MINTUES AGO AND I FIXED IT U JUST HAVE TO PRESS THAT LITTLE BUTTON ON THE SIDE THAT MAKES IT BLINK BLUE AND RED

pass keys 4 headsets are normally 0000 or 1234 unless you've manually changed it. If so then you will have to go thru each number cycle from 0000, 0001, 0002, up to 9999. (",)

press on call button and hold it till the bluelight comes up

When the afterglow headset flashes from red to blue, it is in pairing state, youve held the power too long after power-on. Shut it off again and turn it back on and dont hold the power button untill it flashes red to blue. The directions provoded with it aare quite easy to follow. Took me 30 seconds to set mine up

Sounds like you may have a defective unit. If it is under a year old I would contact the manufacturer immediately for a warranty replacement. Or you can start by taking it back to the store you bought it from if they offer any tech support. Hope this helps. Have a great day.

ya im having the same problem with mine, and im trying to play cod6. but i think its supposed to do that. but then again, why would they give u a earpeice if u cant hear anything. well, u can try pressing the volume up on the head set, and also go to accessory settings on your ps3 and turn it up. but im not sure if thats your problem, i havent tryed that yet. but hope it helps.

Wiring a fridge thermostat typically involves connecting the thermostat to the power source and the compressor. Here's a general guide for wiring a 3-pin thermostat:

1. Identify the Pins: The thermostat will typically have three pins labeled 4, 6, and 3.
2. Connect the Power Source: Pin 4 is usually the common (C) terminal, which connects to the power source. This could be the live wire from your electrical supply.
3. Connect the Compressor: Pin 6 is often the normally open (NO) terminal, which connects to the compressor. This allows power to flow to the compressor when the temperature rises above the set threshold.
4. Ground Connection: Pin 3 is commonly the ground (GND) terminal. This should be connected to the ground wire for safety purposes.

I recommend RadioReference.com, they have detailed lists from all over the United States. In addition to frequency lists, they also include live audio, HAM radio lists, licensing information and a lot more.