20 Most Recent Pioneer inno2 Portable XM Satellite Radio Receiver with Home Kit - Black Questions & Answers

I fixed the reboot cycleing problem by plugging the travel charger into the jack that also fits the home and car cradle. I had the Inno set to auto start when it was powered on in the car cradle. The travel plug must have over-ridden the auto-start setting and allowed it to finish the complete bootup. I then reset the Inno default settings and every thing was back to normal. I do not know what was the original cause of the rebooting cycle problem

Are you using a car dock with the sure connect wiring system, or an mp3 patch cord from the Inno to your auto radio with aux. input?

Welcome to Fixya

This is not a battery problem. Try to plug in the unit usint a travel charger into the jack that also fits the home and car cradle. Have the Inno set to auto start when it was powered on in the car cradle. The travel plug must have over-ridden the auto-start setting and allowed it to finish the complete bootup. Reset the Inno default settings and every thing will be back to normal.

If this will no fixed your problem, then you need to bring the unit to Pioneer service center and have the firmware rei-nstalled.

Thank you for using Fixya! If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

The power or out put ic could be damaged. Please visit a qualified technician to check on this. You couls also check if the female part of your stereo jack pin is okay.

I use my car dock, with a dc cable.

If anyone can help me with why my radio is not responding to the remote, please let me know. The battery in the remote is good, and I've tried a new remote, but the radio just won't respond to the remotes.

Have to use a car dock to use the fm transmitter.

It sounds like the radio is not activated. If it isn't, go to xmradio.com and follow the instructions to activate it. If you have activated it, and you are still getting only two channels, either go to xmradio.com or call them and you can "refresh" the activation.

I feel your pain. Unfortunately, I haven't been able to find any car docks, there all discontinued. (sorry bums!)
But, when I'm riding my motorcycle, I put a rubber band around the radio and dock, holding it in place.
But, in a place that doesn't interfere with any buttons or the display.

I just spoke with Pioneer for this same issue. They said they do not repair the inno2 because it's not cost effective.

Just stays on the Please Wait...screen - How can I rest it?