20 Most Recent
Whirlpool Cabrio 7.0 Cu. Ft. Super Capacity Plus Electric Dryer - Page 3 Questions & Answers
Leak at left side and front of lid model #8240ywo
Be sure and check if the flooring is in good straight flat surfaced,if it is,then re tighten all the screws/bolts around its body and it`s back,then put level bar on top of it,if it is not leveled properly,re adjust/turn the four legs of unit until you achieve the dead zero level on your level bar.
How do i take off top of dryer to change belt
Unplug the dryer! My dryer top is hinged in the back, so I just gently pry up the front of the top after unscrewing the lint trap. Then there are two screws near the top of the front panel holding the front panel to the sides. Remove screws, then the front panel lifts up. The drum will drop down. You can now remove the drum since the belt is broken. Check the back rollers, clean the motor, clean out the inside of frame, replace the belt - making sure it is fed through the idler properly, install the drum- working the belt around the drum, making sure the belt is not twisted and in the correct position on the drum. Reinstall the front panel, making sure the drum is seated properly on the back panel and on the front panel, now you can lower the top and have at it. Your dryer may be alittle bit different but a dryer is still a dryer.
Code error f 22
It could be the thermistor, which is like a thermostat, which shuts if off early.
Why is my machine starting filling up a little then stopping for good
Most of these washing units have a weight distribution sensor. If it senses an unbalanced load it will stop. It is also possible that the bearings that support the drum are damaged and the sensor is preventing the washer from continuing normally. You could also be experiencing a faulty main control board, or a host of other sensor issues.
Whirlpool
I think your old plug is probably 120 and you may need to convert to 220. It's probably the wiring is probably 220 in new home? Or maybe not grounded properly. This is a job for a professional. If you think you know what you doing, we try to save a few dollars by doing it ourselves. But sometimes it is time to call the experts, before we cause more damage and cost us more money. Good luck!
How to change belt?
Make sure power is off, take off back panel, slacken belt tensioner or motor, replace belt. It should be that easy.
How to change heating element for accudry
ear cover has to come off. Make sure the heating element is the culprit. Do a Continuity test across the Connector. If the Thermostat fails, you will not get heat either
My washer gets unbalanced load with 7 minutes remaining
My bet is that the 7mins remaining point is exactly the commencement of the spin cycle. Does it do it every time or once in a while but always 7mins remaining? If it is once in a while then it is most likely just an improper loading problem. I need more info for a better diagnosis.
My washer always gets unbalanced load with 7 minutes remaining.
This sounds like a problem with an unbalanced washer or unbalanced load. Your washer has four leveling rubber screws underneath. To keep it from rocking make sure all four points are touching the floor at all times. Washer machine being level is a great plus. Also it could be the amount of clothes put into the washer. The more clothes you put in the less chance of your load being uneven.
Not finding what you are looking for?