20 Most Recent GE Spacemaker Washer and Dryer Electric Laundry Center - Page 5 Questions & Answers

lint traps are typicaly only on frontload washers

It could be the heating ellement(s)They can be found by taking the back panel off.Before doing ANYTHIG unplug the dryer to avoid injury.

It is possible that the machine does not start off the cycle because there are errors due to feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven starting from the flow of water into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect.

the drain hose is on the back. it's generally the biggest hose on a washing machine and in most cases black. it could be kinked or clogged. once you locate the hose it's held on with a clamp. undo the clamp and it pulls right off. if no clog or kink there follow the hose to the drain usually on the wall and look there. I doubt it would be or else you would have water all over the floor so my guess is it's not even leaving the washing machine. Also something to keep in mind is that it could be the pump that draws the water out.

sir you may check the connection of power supply and motor connection for possible short circuit, that cause of water.,.,^^