20 Most Recent Samsung 1.8 Cu. Ft. Over-the-Range Microwave - Page 5 Questions & Answers

The small plastic plate on the microwaves door with the spring it it needs to be replaced.

E-32 error means you have a wiring or circuit board short. Easier or cheaper to replace without a lot of aggrevation.

At 12 years old, time for a new control panel.

Switch it off from the wall for a few seconds , then witch it back on and set the clock , this should reset it , if not contact a service man .

TRY A DEALER

Contact Samsung directly to request the manual or do an online search.

1. Damaged or defective door interlock 2. Defective control board

Either the display or the control board could be at fault.

It is prompting you to close the door, but if the door is closed already, the code may be an indication that the door interlock or associated wiring is at fault.

Request the manual directly from Samsung.

fixya does not provide instructional videos. Check YouTube.

Defective door interlock or related wiring

Defective keypad or control board

Close the door

What the manual tries to say is that if the touchpad membrane switch aka "membrane" has failed, the control board/panel may have failed.

There should be a button labeled timer. Hit that then enter the time you want it to count down to. Then hit the timer button again.

Most likely just a 1/4 inch

The screw might be hitting a live wire in the wall which is very dangerous! Make sure there are no live wires where the mounting goes.

Usually after you remove the 4-6 necessary screws you should be able to give it a jerk downwards (carefully) as not to rid any wires. Most microwaves have little notches and hooks that are not too difficult to work through, but it's just finding th

The SE error code indicates that you have a stuck key on the control keypad or a failed electronic control board. A technician will probably need to diagnose and repair this type of failure. microwaves are inherently dangerous to service.