20 Most Recent Whirlpool Duet 4.0 Cu. Ft. Steam Washer - Page 9 Questions & Answers

yes they can be stacked

inlet valve stuck open replace

replace valve

probly the noise supressor capasitor folow mains lead into back of mechine u will have mains lead going into it 2 other going out of it to mech components good place 2 start good luck tom.

i think phillips had something to do with wirlpool at one stage

This is a warranty situation. Contact the seller. Otherwise you can take the panel off under the door. There are three screws on the bottom edge. You lift and pull the panel off. You can then see the drain plug and you unscrew that. If you do that though you will get ALL the water from the tub to spill out on the floor.

There is no way to "turn down" the noise on any washer other than to balance the load of the washing machine tub as it spins. Typically the washer increases noise due to spinning during the rince and dry cycle. This noise is a consequence of the rapid spin rate needed to dry the clothes using centripetal acceleration and removing the water.

1. Disconnect power for at least 30 seconds. 2. Re-apply power and observe for at least one minute. 3. If code re-appears, replace control board (also called ERC or clock). Read more: http://www.appliancepartspros.com/repair-help/whirlpool-fault-codes.html#ixzz3PsUurTNH http://www.appliancepartspros.com

Whirlpool Duet Sport Washer will not drain 21 error

IF AFTER THE MACHINE HAS BEEN OFF FOR A TIME DOSE THE DOOR OPEN? IF NOT THE INTERLOCK SWITCH COULD FAULTY OR THE MOTOR BRUSH WORN or LOOSE CABLE LOOM TO MOTOR, (model number would help)

when the machine is stopped can you empty the residue water that remains by the programme selector? if not check for blockage in the pump(coin), the hose internal blockage ,or at the outlet under sink. I hope this help

seems to be the bearing has gone the drum(inner metal) is rubbing on the outter which is plastic . this will eventually cause leaking

im gessing its a front load.. under the door switch there is a plastic tab that you pull about 1 cm down it aint easy to reach but its there you need to slide your hand in there and feel it

Try unplugging it for about 5 min and allow it to reset and plug it back in and try it again.

Almost certainly faulty bearings check for vertical movement in the drum if so, not good very expensive repair

You need to replace the door boot and dry out the bottom of the machine

Chek that the door lock is activated if not replace the door lock the other possibility is the anti flood device is activated so chek for a leak in the bottom of the machine

Check the filter and drain pump

It sounds as if you have a split pipe or a detached pipe from the top loading drawer or the pump is blocked and back filling to a place where it can leak out .
Check the pump is not blocked up first .
Then take the lid off without touching anything start up the machine, get a torch and look for a leak . Make sure you don't touch any wiring whilst the lid is off or you may get an electric shock.