Lexar FireFly 2GB USB 2.0 JumpDrive - Page 8 - Answered Questions & Fixed issues

Error. Over Current - Peak current exceeded Possible causes: Motor has a short - Phase to phase or phase to ground. Motor cable damaged/defective. Motor cables too long. Acceleration/deceleration ramps too short. Damaged output phase of inverter. EMI

Three years is pushing the life of the batteries. Have them checked where your type of battery is sold.

You can use Card Data Recovery. It is the professional SD card data recovery software. It can recover photos, video, audio and documents from SD card, miniSD card, micro SD card, etc. This program has two versions, one for Windows users, one for Mac users. You can visit its official website to have a look.Card Data Recovery for WindowsCard Data Recovery for Mac

it means you can't write new files or alter the files. It is cs26466 ? this has a password protection feature apparently is it an sd card ? move the tab on the side of it If it is a usb flash drive I do not know how you get pass the passwor dor how you enter a password when accessing it ?

Write protect in flashdrive could mean chip problem if you cannot partition or reformat the usb drive..you can try usb low level format, partition application..be sure to back up files before doing so.

When Ally starts chanting "I need my pack", it can become your worst nightmare. I can't find "the pack" but I'm guessing it's the keypad that you plug into her wrist. My bet is the pin/plug connectors in these dolls were not super awesome quality wise and sometimes didn't register they were connected (the program cards were a bit glitchy as well). Once the batteries need replacing, the doll needs to be reprogrammed hence the keypad connection request. Just a guess...

I don't know how new these are, but there is one trick to try to recover a battery. Make sure it discharges completely(will not turn on at all, no matter how hard you try). Then charge it completely. Continue to discharge and recharge, (again, when discharging try again and again to turn it on till it will not come on at all). This process should start to help the battery get back it's charging 'memory' and you should notice the battery last longer and longer with each charge. If this does not work, there is a problem with the battery. Good luck!

Here is an excellent article that should help you. https://www.stellarinfo.com/article/sd-card-recovery.php

These are all messages that follow overheating. E.nOH indicates that the heat sink has returned to the normal temperature range and the unit can be reset. E. OH indicates that the power module is over-temperature. This could be caused by insufficient air flow at the heat sink. That is caused by dust/dirt. The ventilator could be clogged or the ambient temperature is too high. E. OH2 indicates that the motor protection relay was tripped. Check for dust/dirt and clean any filters. Make sure that nothing is blocking the air flow around the unit. KEB uses these error mesages on the CombiVert F6, https://www.keb.de/fileadmin/media/Manuals/f5/control/f5m/00f5mebk320.pdf . I hope this helps. Cindy Wells

defective charger

Hello Shakeel, the PG156R diode, you can replace it with any fast diode of 1000 Volts, 3 Amper I send you a link for you to unload the PG156R datasheet and another about the replacement I hope you can solve the problem Greetings Franco Dosil Hola Shakeel, el diodo PG156R, lo puedes reemplazar por cualquier diodo rapido de 1000 Volts, 3 Amper te envio un link para que descargues el datasheet de PG156R y otro sobre el reemplazo Espero puedas solucionar el problema Saludos Franco Dosil https://pdf1.alldatasheet.com/datasheet-pdf/view/406020/PANJIT/PG156R.html https://www.yoreparo.com/tv/televisores/tubo/preguntas/1412382/puedo-reemplazar-diodo-pg156r-por-un-rg10 https://www.yoreparo.com/tv/televisores/tubo/preguntas/1284512/reemplazo-de-diodo-uf156 PG156R NTE Equivalent NTE571 1000V 3A soft recover

the inverter has tripped or fuse blown...

alternating current 3 phase....

Hi, guessing you are from the UK? Different countries operate different regions for dvd's for instance the UK dvd players are set up to play region 2 discs, and US dvd players are set up to play region 1 discs.
This is because dvd release dates are different around the world and this stops people buying a dvd in the US and bringing it back to the UK and selling it before its official UK release date for example.
Your choices are either to play the dvds on a PC where often the dvd software will allow you to change region a number of times (be careful though as some players will let you change region say 5 times and then be locked to that region)
Or to get hold of or buy a multi region dvd player which plkays dvd'd regardless of their original region
Hope that makes sense, good luck

What make and model is the inverter?

I have a Blu Dash X and have 2 sim cards plus a micro SD. If you can get the back off (a fingernail in the little crack on one of the corners) you can open it up and slide the card into the slot that is marked for it. The contacts go toward the front of the phone.

The more things u put on your phone the slower it gets probably u got a auto delete function on it but need more info to diagnose

There should be a default password. Try that.

Put in Google charging cord for and then your model

On what???