20 Most Recent Dacor ECD230 Epicure Electric Double Oven - Page 5 Questions & Answers

Basically, it is 22 years old and ready for replacement.

I have a DACOR double electric oven model ECD230SCH. the top oven lower element went out 1 and 1/2 years ago, but the top element broiler works. Yesterday the bottom oven did the same thing- bottom element not working along with convection. Pulled off doors and cut breaker. Checked thermal switch on top off oven- closed good. Pull out element and Ohm'ed out- good. Now pulled over and out oven top panel to get to the control boards. Found a nice set of schematics for the over control boards and electronics. Sat down and pin-pointed both relays that supply power to upper and lower oven "lower" heating elements. these are on 2 different boards- upper over relays on bigger board on the left with the transformer. Lower oven on the right smaller board. Hardest pain in the rear was just getting the little plastic stand offs to push back through the board to get it off. Finally got it off and inspected board. Low and behold the relay I pin-pointed had a burn/open connection on the solder joint. Re-soldered tested oven and lower oven lower heat element works now! Went to the next board and got that off and same exact problem on the rely for the top oven lower element. Re-solder and test- good!! Put everything together and ran over to 350 on top and lower and back to normal. Wife very happy she did not have to pay a repair man big bucks to swap out the control boards- would have had to replace both. I have a degree in electronic technology so as a technician for many years did low and high voltage component level repairs. But pretty easy and you can visually see the open solder joint on the back of the board at the relay leg. Jim B Roseville, CA.

https://www.youtube.com/watch?v=XaUmMeh-vqA

FixYourBoard.com will test and remanufacture the relay oven control board in this model. Each rebuild comes with a two year warranty. Reach out to us at 512-355-1108 or [email protected]

FixYourBoard.com will test and remanufacture the relay oven control board in this model. Each rebuild comes with a two year warranty. Reach out to us at 512-355-1108 or [email protected]

were the both the same voltage and don't touch the bulb with your fingers us clean rubber gloves

https://producthelp.jennair.com/Cooking/Wall_Ovens_and_Ranges/Oven_Product_Assistance/Possible_Causes_for_Poor_Baking_Results https://www.samsung.com/us/support/answer/ANS00060968/ https://products.geappliances.com/appliance/gea-support-search?Nrpp=96&No=1&Ntt=double%20oven

Check online or maybe EBay

C77 means replace glass / touchpad assembly

Step 1 Locate the "Clock" button on the display. The display is located above the oven door. It clearly shows the time and has settings for temperature, time and cooking. Step 2 Press and hold the "Clock" button until the time starts to blink. Step 3 Set the time with the number pad. Ignore the colons and enter the number straight through. For example, if the current time is 10:08, just type 1-0-0-8. Step 4 Set AM and PM by pressing the "#" button. Press "Start" to finish.

Page 9-48 in technical manual excerpts at the link below: http://www.uncleharrywizard.com/nephewclub/WizardRange/dacor/dacor-wall-oven.pdf http://www.uncleharrywizard.com/nephewclub/WizardRange/dacor/dacor-wall-oven.pdf It says to call for service (by a technician). (I am only reading it from the document - I am not a technician.) It says to replace glass/touchpad assembly. It says wrong or unrecognized diode configuration.