20 Most Recent
Dacor MCS130 Millennia Electric Single Oven - Page 2 Questions & Answers
F1 error relay circuit failure
Hi This is the Alarm system watchdog circuit : The system has detected a failure in the internal watchdog element , relay circuits and will atcivate a cancel feature. F1 will be displayed in the time digets and will beep until the cancel button or another funtion is selected. An F1 failure could be detected in cook or time of day mode. With an F1 failure the ERC is picking up a comand to supply heat without receiving an input from the membrain. The watchdog circuit is designed to prevent this.If the beep continues after pressing cancel check the main control ERC board.
The oven lights1 in my
Sounds
like some of the internal components that work with this device
is not working properly, the problem could be even more delicate
(electronic) or any circuit braker, fuse or switch; so I suggest you open the control panel with a qualified
technician.
Good luck.
F1 error
Failed control board(micro-processor) replace board.
Known Dacor oven problem-
Oven light
The touch membrane is gone. You can replace it (like i did) and wait for the next thing to go wrong. Took me 3 months for the next problem, and the membrane was $300.
Dacor single oven flashes an F2 error code and won't stop beeping!!!
This is from
manufacture service manual:
-F2- Alarm Heating Mode High Temperature
Is activated when the
ERC senses a runaway heat condition or when the temperature exceeds
“runaway limits”. The
ERC will beep until the cancel or another function is selected. If the alarm
repeats the F2 alarm check the oven sensor and wiring after fi
rst checking for a stuck relay. If alarm
goes away verify the oven will complete a clean cycle without any type of failure.
Another words the problem with oven sensor or
relay board. I’m happy to help further over the phone at
https://www.6ya.com/expert/vitaliy_f406165329c75ede
Dacor CPS 130 oven will not heat
This model
actually made this way. Sometime you can not see the thermostat because of the bracket in front of the door latch. When you remove grill panel under control panel you gonna see this bracket. It pulls out very easy. Behind the door latch you will see thermostat with red button on the middle. Before
resetting this button make sure you
disconnect electricity. I’m happy to help further over the phone at
https://www.6ya.com/expert/vitaliy_f406165329c75ede
Melted foil in oven
try this take them out if the oven they just unplug in the back soak them in a de greaser with lemon juice really hot water let me know if this works
Oven thermostat
Hi Andew 799.
It sounds to me like your oven element(s). is faulty
If it is a fan assisted oven then you should check that first. You will need a multimeter to test it.
If it is a conventional oven, then it will have 2 side elements, and it is possible one has gone, thereby only giving you half heat.
The other possibility is a faulty thermostat probably cutting off prematurely.
You must check the elements first.
Hopr this helps.
Good luck.
Not finding what you are looking for?