20 Most Recent Frigidaire FAA065M7A Air Conditioner - Page 5 Questions & Answers

The problem is in the thermostat wiring, likely it is grounding somewhere between the thermostat and the air handler/furnace unit.

Excellent question - go to web site for significance of code so you know where to look during your DIy activities.

Code 'E6' does not show up. Here is the Sears website with codes. It also shows problems and fixes which may help you narrow down your problem. Model FFMS221WQ20 FRIGIDAIRE SPLIT ROOM AIR CONDITIONER Parts

Water going outside is the important part. The hole is not necessarily the drain, the angle at most is an eyesore! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

I've never seen a reset on a window unit. Normally we have a gfi button on the plug that goes into the wall. Or by unplugging, and plugging back in will reset it.

Need model numbers!! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

I didn't think portable acs have tstats. What's the model number? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

unplug it if you can and let it set for 20 minutes, set the temp control where you want it and plug it in, wait a bit and see if it starts cooling. you can confuse these things if you turn it off and on rapidly or change the temp control up and down sporadically. The compressor has to take it's time to kick on after it has been shut off and then on again.

This unit is a 220 volt ac unit. 12-2 wiring is usually for 120 violt circuits?

Amps: 22.2 / 20.0

Watts (Heat): 4900 / 4000

Watts (Cool): 1650 / 1625

Amps (Cool): 7.7 / 8.3

Voltage Rating: 230V / 208V 60Hz

Power Cord Length: 5' (6')

Horsepower (Cool): 2.49

Plug Type: LCDI 6-30P

http://www.frigidaire.com/Home-Comfort/Air-Conditioning/Window-Mounted-AC/FFRH1822R2 hope this helps?

Sounds like a high pressure fault. Is the outdoor fan running? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Sounds as if your blower wheel is damaged or the balance weight has dislodged. Turn power off and inspect blower wheel. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

It SHOULD NOT ... (smell in... even in WEST TEXAS). BRAND NEW... Rush on down and get a good NEW one. I would suspect the condensate drip pan is plugged... Common for AC units .. But NEVER in "brand new"... Get that (previously owned (my opinion)) UNIT back from where you bought it ... Trade it in for a CLOSED BOX... and make your sales CLOWN write up why you are returning it. Mold can be quite dangerous!! Carnac the Magnificent