MTX Thunder 6000 T61544A Car Subwoofer - Answered Questions & Fixed issues
I have a hole in my Kenwood is it fixable ?
Depends on where it is but if it is in the middle of the cone, you can use a light weight plastis and glue it over the hole or if it is a really small hole, a piece of tape o. The backside and some epoxy or jbweld on top. The tape just keeps it from leak in g thri ugh while the glue dries
Where can i find a
You would have to look for a re coning kit from either MTX site or amazon or ebay
How to bridge a 12
I assume that the sub is a dual 4 ohm and you want a 2 ohm load. It's easy. Just make sure that both positives go to the same positive source and both negative go to the same negative source. It's called a parralel set up. hope this helps
How big of hole do i need for the mtx 6000 thunder
The MTX Thunder 6000 T61544A is a 15" Subwoofer meaning you will need a 15" hole to fit the subwoofer into. The mounting plate that surrounds the subwoofer will extend past 15" allowing you to screw the sub in properly. Be sure to use a box that is at least 12 inches deep (sub is 10 inches deep by specifications + 2 inches for good air cushion behind.
How much does mtx psw101b cost
Since this is a vintage item, the cost is whatever the market will bear, wherever you're trying to sell it. I would suggest checking current prices on sites such as eBay, where one is currently being offered to sell at $200, while another is being offered for $90. The perceived value is what determines the selling price at this point, because the MSRP is long irrelevant by now, being that it's a discontinued item. If you need further help, I’m available over the phone at
https://www.6ya.com/expert/reginald_bec291de192ca44f
Not finding what you are looking for?