MTX RFL152 Car Subwoofer - Answered Questions & Fixed issues

If it is an open air sub ( hole with mesh in the center of the magnet) no ports are required, and the box should be sealed on the inside with silicone sealant. If it is a closed air sub ( no hole in the magnet) you need a 50mm port about 120mm long Box size will be 16 inches x 16 inches x 16 inches

It is too old for online manuals. Any colour light would show it has power and usually a red, green or blue LED. Red is sometimes reserved as a fault condition in conjunction with another power light. https://www.google.com/search?q=mtx+810d+amplifier+manual https://www.google.com/search?q=mtx+810d+amplifier ..

MTX will know that one. https://www.google.com/search?q=make+my+MTX+TERMINATOR+AMP+1+OHM+STABLE ..

See if the videos help https://www.google.com/search?q=mtx+terminator+tna251+RCA+sockets ..

Is a 2ch and 210watts peak power

What amp r u using

yes a higher voltage rating is OK lower voltage rating is not good.

If you have to ask, take it to a repair shop.

power to-battery plus ground;; remote''

THE GREEN LIGHT SHOULD SHOW WHEN AMP IS POWER UP AN RED WHEN IN PROTECTION MODE

Try eBay Often available there from private sellers

I was having a similar issue. I checked every wire from the battery to stereo to amp, checked the ground, pulled the stereo to double check the wiring was all correct. Everything seemed good so I thought it had to be my battery not putting out enough power. Tested it and it was good. What it turned out to be was the connection from the power cord to the battery. It had a tiny bit of built up corrosion that was making the amp go into protect mode. Cleaned it up and hooked it back up and has been golden since.
The link attached is pretty straight up on what you need to check for different circumstances. I'm guessing it's a low voltage issue. Good luck

you have to first note the ohm load the amp can handle and wire the speaker that ther amp can handle

Check the wiring 1st then go down the line...Check speaker connections..Look at your power,ground and remote wire hook up

Since this is a vintage item, the cost is whatever the market will bear, wherever you're trying to sell it. I would suggest checking current prices on sites such as eBay, where one is currently being offered to sell at $200, while another is being offered for $90. The perceived value is what determines the selling price at this point, because the MSRP is long irrelevant by now, being that it's a discontinued item. If you need further help, I’m available over the phone at https://www.6ya.com/expert/reginald_bec291de192ca44f

The mtx thunder is a 4 channel amp. 4 channels can't be bridged to 1 speaker. You can only use one side of that amp to bridge your speaker. Unfortunately your now only using half your amp.

Output fet blown.

You have a short somewhere in the speaker wires.

250wrms is the highest they can take each. So look for an amp that does 500 wrms x1@ 2 ohms or one that does 250wrms X2 @ 4ohms.

Take both positive leads to the positive of the amp. Both negatives from the sub to the negative of the amp. Utilize the bridged output connections. This would present a 3 ohm load which would be around 100 watts rms (rough estimate)