Top 20
Brother CS6000i Computerized Sewing Machine Questions & Answers
Needle not aligned with hole in presser foot
Hi if the needle is hitting the needle plate you best get in touch with who you bought it from, The needle position is a critical adjustment and is done in conjunction with other adjustments.
Most of my stitches are not working properly
I'd contact Brother. No guarantees they can fix it over the phone, but I've dealt with them for years and their service has always been topnotch. If they can possibly help you over the phone, they will.
Service manual
https://www.manualslib.com/manual/451089/Brother-Cs-6000i.html
India 220watts how I cAn use brother cs6000i sewing machine in India
The only way I know is a 110/220 volt transformer.
They are available in any electronics supply house.
As I remember the motors in these machines are only two lead, and they put the motor in for the country it will be sold in.
Dual voltage motors have three or four leads (wires).
How to use 110
Joint us and watch the pinned post videos, ask questions, etc.
https://www.facebook.com/groups/cs6000i/
I have gone through 3 needles and I've never had an issue before. The machine ate my fabric and I pulled it out (big mistake) and now my needles keep breaking.
1. Put one drop of oil on race. The bobbin case has two screws to adjust to keep it from moving either clockwise or counter clockwise. You will need to adjust these. It is tricky but once in the right position it will only move slightly. Give just enough free movement to allow thread to fit through.
2. Adjust the bobbin tension. The screw on the bobbin will need to be adjusted so it has a tension which equals four on the upper tension. This is a little tricky but if you're off a little you can adjust the upper tension to correct this. NOTE: You are trying to adjust the upper tension and the bobbin tension to be equal. This is similar to a tug of war.
3. Try to turn the hand wheel. Watch to see if the needle thread will ride across the top of the bobbin. It should do this without the thread getting stuck. If it gets stuck you will need to adjust the bobbin case screws to allow a little more movement allowance.
4. Replace the needle.
5. If you still notice the needle striking something under the throat plate you will need to have your machine timed.
Not finding what you are looking for?