20 Most Recent Frigidaire 17.8 cu. ft. / 504 liter Commercial Freezer FFC18K1CW - Page 3 Questions & Answers

look at level side to side , and front to back. if not level door can leak . you will see water where it is leaking. check defroster is if staying on .

This link might help you troubleshoot Freezer Frost inside Symptom Diagnosis Sears PartsDirect The lucky solution is if the door seal or inner plastic liner need to be placed/repaired (this lets warmer air into the freezer causing frost and poor cooling). But you can also see from the link that your symptoms could be caused by other electronic related things...more of a challenge to fix... Helpful? Good luck on your troubleshooting

have you tried unplugging for 5 minutes to see if it resets?

https://www.repairclinic.com/RepairHelp/Refrigerator-Repair-Help I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

If you are talking about an external light, it is most likely a neon indicator light that tells whether you have lost power to the unit. Blinking is normal with age or power fluctuations. I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

If compressor is running, have you given it enough time to recover? or you may have a faulty thermal protector on the compressor. Cold control setting on right position? I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

Cold control probably failed =36 is too cold. -10 to=15 is all you need. https://www.repairclinic.com/RepairHelp/Freezer-Repair-Help This link will have parts and repair help I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

There should be a temperature adjustment inside the freezer somewhere. It will look like a slider or a dial, and be labeled something like "Colder" and "Less Cold" on opposite ends of the scale. If this is set to its coldest setting, and the temperature still is not cold enough to solidly freeze food (ideally, a freezer's temperature should reach ZERO degrees Fahrenheit), then the unit needs to be serviced by an appliance repairman.

I believe the Frigidaire owner's manual will give you suggestions. I have a Frigidaire and I keep mine on 4. That is the middle point. Set it there then wait a day or two and make sure you have nothing freezing inside and items in your refrigerator are cold enough for you. It's your personal preference.

Sounds like one or more of your defrost components are bad. Those components are defrost heater, defrost thermostat, and defrost timer or board depending on model.

Possibly loss of freon.

Freezer should be set to 0 to -5

First culprit could be a refrigerant leak and needs to be charged. If the evaporator is frozen solid it won't push enough sub zero air to freeze. Call a trusted ac&or repair man

It says manufactured 5-00 The 5 is fifth month which is May and 00 is the year 2000 It was made in May of 2000. I think by looking at the model number it is 13 cu ft.

Remove back plate and check to see if evaporator is frozen over. If so, your defrost timer/heater is not working. Till repaired defrost unit completely. It will work fine till it freezes up again or you make the necessary repairs. Not hard to do just a PIA.

The defrost element and/or timer.

Is compressor running? Check the start cap/relay for operation. Go to site for parts if necessary Search Over 2 1 Million Appliance Parts