20 Most Recent Hamilton Beach Water Cooler with Storage Cabinet - Page 6 Questions & Answers

You are my 40,000 question that I have answered! You don't get a prize, but I think that is pretty neat Paul :>D I have been here a long time. The manual only says that you have to make sure that cooling is switched on (Page 12). The unit has a 1 year warranty. If it out of warranty, you just need to pick it up and take it to a refrigeration engineer. It may need topping up with refrigerant gas. Consumer Support Questions? How to contact us: Telephone 800-488-5080 (Monday - Friday 8:00AM-5:00 PM ET) E-mail: [email protected] [email protected] https://useandcares.hamiltonbeach.com/files/840178600.pdf There are some videos here that might be of interest. https://www.google.com/search?q=Hamilton+Beach+Bl-1-3+water+cooler+not+cooling+the+water Hope the information helps you. ..

Would be nice if you write what kind of car it is.

Contact Oasis to request the manual.

CHECK YOUTUBE SEARCH AS I found Hamilton cooler.

How to Set the Temperature on a Primo Water Dispenser

1. Move the Primo water dispenser away from the wall, being careful not to tip or spill the water bottle.
2. Locate the flat, brass-colored screw on the back of the water dispenser.
3. Turn the screw slightly clockwise for colder water or counterclockwise for warmer water. ...
4. Check the temperature of the water.

Please share the make and model of your filter.

press the rest button or get a new cooler as the compressor is not working

pump failure --seal leak --kinked or damaged line

broken or stuck spring --bring back for repair or replacement

nope fixya doesnt sell products

Refer to manual that came with unit. Big hint page 14 Even bigger hint and book mark this site. https://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-50283-11.pdf

turn the main stop **** off then repair and re seal were the leak is

Are you sure that the unit didn't blow its circuit breaker in the new location?

First, I'm not a Earmark tech. * Contact your water provider for service. *** The following is for information only *** * common problems with priming bottom loaders. Here are some vids to help; https://www.youtube.com/watch?v=_ZV36EQnj4A * Set up (more technical); https://www.youtube.com/watch?v=239zY93bYrg Aloha, ukeboy57

manualslib... did resonate with your model... (you will have to look here... https://www.manualslib.com/m/myl1032s-b.html Hope this does it for you...

The noise is normal during regeneration and draining. You can manually set the regen clock to a different time. There are Noises in My Culligan Water Softener Regeneration System Hunker

Make sure you have enough water pressure for the dispenser. Most RO water filter systems require at least 40 PSI line pressure.

Mark and unhook all the tubes from the filter. Take it out and place it on a table horizontally. This is all about correct leverage. While holding the reverse osmosis system in one hand, slide the wrench into a canister and turn it counter-clockwise. If this still does not work, you may have to soak the filter canisters (bottom housing part ONLY) in warm water with vinegar and try the steps above again. How to change 10 RO Pre Filters

There might be a low pressure sensor inside the purologix system that is preventing the cooler from dispensing water. In that case you may need to install a booster pump to increase water pressure into the storage tank of the ro system. Check if you installed the ice maker correctly as well. https://www.wecofilters.com/pub/media/productattach//i/c/ice_maker_kit_manual.pdf