20 Most Recent
HP Photosmart C6280 Printer - Page 8 Questions & Answers
My HP Photosmart C6280 printer
Welcome to Fixya
Try to restore the printer back to factory default settings. You can perform this process from the control panel only.
To restore the factory defaults
1. Press Setup.
2. Press to highlight Tools, and then press OK.
3. Press to highlight Restore Factory Defaults, and then press OK.
The factory default settings are restored
Thank you for using Fixya! If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
Can't print without black Ink
From HP's website:
The printer will not operate unless all six ink cartridges are installed. Also, HP cannot guarantee the quality of refilled or remanufactured ink cartridges.
Try this::
Leave the empty cartidge in and go to print, select the printer, click on preferences, then the paper/Quality tab. there select color and best. This way you wil be able to print your document.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe
I’m happy to assist further over the phone at
https://www.6ya.com/expert/joe_8b8c2cd6ce148309
Printer says ink system failure error 0xc18a0206
Disconnect the Universal Serial Bus (USB) cable from the back of the product, but leave the product turned on.
Open the cover of the product and remove the print cartridges.
Close the cover and wait for the Insert Ink Cartridges message to display.
Disconnect the power cord from the back of the product and wait for one minute.
Reconnect the power cord. If the product does not automatically turn on, press the Power button.
Open the cover and reinsert the print cartridges.
Close the cover. If prompted, print a calibration page.
Reconnect the USB cable, and try to print a print job from the computer.
I bought my HP Photosmart
it is likely that you havr a mix of trade and host supply of ink cartridges. Even though HP363 and HP177 are compatible cartridges it is not the issue. Refer
this article.
Hope this helps.
All in one printer c6280
hi, I want to scan a
http://h10025.www1.hp.com/ewfrf/wc/product?cc=us&lc=en&dlc=en&product=3194498
Above is the link to the manuals, software, and drivers for your printer.
uninstall the printer, reinstall it, and if the option to scan to pdf hasn't returned consult the manual.
0x05d1281
That means your printer has an ink system failure, and could possibly need replacement. However, before you try replacing your printer, try using this guide
Ink System Error Guide.
ERROR MESSAGE
1.Press '*' key on the key pad, then press the '#' key and release them both.
2.Then enter '123' to enter maintenance mode.
3.then press the right arrow (beside the OK button) until System Configuration menu
appears on panel.
4.Then press OK two times to clear the error
condition,
5.then cancel two or three times to return to the top menu.
6. Then power off and back on, print a test page
If this does not help you then the printer need to be replaced you can call HP and talk to the Supervisor
The printer will not recognize
Your new cartridge may not support your printer. Actually some duplicate cartridge have the problem. You can try to install cartridge properly. Hope your problem may fixed.
Where is the battery located on the HP C6280 All-in-one printer?
Inside silly. ;)
(sorry couldn't resist)
Unplug,
Remove the right hand plastic side panel.
Ground yourself to discharge possible static electricity,
Remove the 5 screws holding the cct board.
Battery is on the cct board.
Be careful of damaging wires when reassembling.
Not finding what you are looking for?