20 Most Recent
HP Photosmart C6280 Printer - Page 3 Questions & Answers
How do I incress the size of my photo
Press "Copy Menu" The copy menu appears
press "down pointer" to highlight "Size" then press "OK"
The Size menu appears
press "down pointer" to highlight "Custom 100%" then press "OK"
The Custom 100% menu appears
Press "down pointer" or "up pointer" to select a percentage to reduce or enlarge the copy.
Press "OK" when happy with percentage to enlarge
http://h10032.www1.hp.com/ctg/Manual/c01150745.pdf page 91 and 92
0xc19a0002
Switch on your printer.
Press and hold the * key.
Press the # key and release both keys.
Display should say Enter Special Key Combo
Press and releasethe key in sequence 1, 2 and 3 buttons.
display says "support" R0631M
Press and release the right arrow button
until the display says " System
Configuration Menu".
OK button.
Display should say Hardware failure status. If not there already, Arrow Key
over to Hardware failure status
Press and release the OK button.
Display should say Hardware failure status: Clear. Press OK to clear.
Press and release the OK Button. Message
changes to Hardware failure status
Cleared. Press Cancel to continue.
Press and release the CANCEL button as
many times as necessary, so that, either the Welcome to Photosmart Express screen appears, or, the Ink System Failure screen appears. PLEASE DO NOT TRY TO PRINT AT
THIS STAGE.
Using the Power Button, turn the unit OFF and unplug the power cable from back
of the printer and wall outlet.
Wait 30 seconds for the power to get discharged and then plug the power cable
into the wall outlet first and then into the back of the printer
Turn the unit on. The printer may
display message USE POWER BUTTON TO SHUTDOWN THE PRINTER followed by PRESS OK
TO CONTINUE. Press OK. The Printer will start the ONE TIME INK INITIALIZATION
PROCESS. Allow this process to complete and do not interrupt. Once the
initialization process is complete, the printer will print out a Diagnostic
Page..
Hp photosmart C6280 ink system has failed.
Please follow the below steps.
STEP 1.
1. Un plug the power chord from the back of the printer.
2. Press and hold the power button of the printer.Wait for 30 seconds.
3. While holding the power button, re-plug the power cable.
4. Turn on the printer, if it is not on.
STEP 2.
Reset the All-in-One to the factory default settings by using these instructions:
1) Press Red Eye Removal & Print Photos button simultaneously
2)Enter Special Key Combo is displayed on the screen.
Press and release in sequence "Red Eye Removal", "Print Photos", "Red Eye Removal"
Display should say "Support" and display the FW rev XXXXX.
3) Press Right Arrow button untill "Reset Menu" is displayed. Press OK.
4) Press Right arrow untill "Semifull Reset" is displayed.
5) Press OK.
Not finding what you are looking for?