20 Most Recent Frigidaire 24 in. FDB510LC Free-standing Dishwasher - Page 9 Questions & Answers

The water inlet valve could be faulty or possible some obstruction in it.

It could have been installed with it in a bind, making it out of square. Make sure it is sitting level on the floor and not tilted. Make its not binding on the sides or top of the cabinet.Hope this helps.

Sometimes a little piece of debris such as a toothpick, chicken bone, etc. can get past the screen and make it into the pump. The wash arm pulls right off and the part holding the screen can be remove with a twist. remove the screen and then you will see the impellar in the pump whee the debris is at. Hope this helps.

Blocked . Clean filter . Try drain clear in the bottom may clear blockage

Not to degrade your question in any way but unplug it let it sit for a couple of minutes then plug back in. will reset the cpu. plug is under the counter somewhere usually under the sink. Hope this helps

connect the drain to the correct disposal pipe

Could be the circuit board behind switch.

The spray arm needs to be removed to gain access to the filter, once the spray arm has been removed the filter should just lift out.

The spray arm needs to come off to gain access, once you remove the spray arm it should just lift out.

No you can't unless you are trained and have the repair manual.

call the technician to properly diagnose the fault