20 Most Recent Frigidaire GLTF2940WH - Page 7 Questions & Answers

yes it can, but no one can tell what parts are needed as they are not there to look at it. best solution is to call for service.

On occasion, the manufacturer will in include paperwork inside of the back. You would have to remove the rear cover or panels.

Any error codes? Drain pump may be blocked.

Sounds like the water pump seal may be leaking.

Does this machine have the 'old style' mechanical control timer unit the you rotate the dial? If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Jason, take a look at this link and follow the steps very carefully. Were insulated golves. How to Fix an LG Front load washer machine that wont spin

This sounds like a similar fault I repaired on a Fisher Paykell top loader smart drive. It would fill up, start it's wash cycle (you'd hear the engine turn back and forth ) and a second later stop. It turned out that a position sensor on the motor had failed due to a small water leak. I'm unable to find the motor for your model of Frigidaire to see if there is a similar sensor or pick up module though.

I don't understand SHANE circuit board. IF you replaced the board, it has been upgraded and you need to order a new wiring harness for it. Please post the model number

Check if your water supply is coming in very well

You probably have a broken door (or lid) switch. You will need to replace it, as they are usually cheap plastic, easily broken, and not too hard to replace. God bless your efforts.

Hey friend, thanks for your inquiry!

I see off your post your Frigidaire washer is showing a "PAU 12" code. Typically "PAU" stands for pause which means the cycle has been interrupted. I would open and close the door to assure that there is a proper connection between the door strike and door latch. If you check that and still receive the "PAU" I would recommend a reset, which can be done by flipping the household circuit breaker off for roughly ten minutes. Hopefully this is helpful. -Matt

Then I strongly suggest you hire a repair tech.

I just had the same E90 code with my "good model" Frigidaire washer. It beeps 9 times, then pauses and repeats. Nothing worked as far as resetting, unplugging,etc. HOWEVER, I saw this guy's video and his "hairdryer technique" worked perfectly.
https://youtu.be/IhHvw2K7XO0
I took it a step further by not only removing the two screws from the back of washer and the top cover, but also removing the front panel w/buttons by taking off two scews in front top corners and three scews inside the detergent drawer (take drawer out first). I moved the hairdryer back and forth over all the wire harnesses for about a minute, plugged it back in and it beeped once like normal. Put it all back together and it's running a load of wash now!! Good luck.