20 Most Recent Frigidaire Gallery GLEFM397DS Electric Kitchen Range - Page 4 Questions & Answers


Hi There
I have the coed for it. But If it's less then a year old you can have it fix for free.Just let you know and here's the coed for you to read.
F1 Circuit board defective Replace control board Thank you for writing to fix ya.
Best Regards Richard

Frigidaire... | Answered on Jan 07, 2010


Hi, If I was being called out to look at your range and you described to me what you said in your post, I would definetly bring an element. I suugest you tell that to your service person or purchase a new element. That is quite often the way the element's burn out, just as you described...a sparkler. Hope that help's. Good luck and thank's for visiting fixya. Macmarkus :)

Frigidaire... | Answered on Dec 11, 2009


YOUR PROB GOING TO NEED TECH LOOK AT THIS ONE ITS NOT A EASY FIX MUST CHECK SEVERAL ISSUES SORRY

Frigidaire... | Answered on Nov 06, 2009


My stove did the same thing after I cleaned it. I had to have the sensor replaced. That is what the F1 code is.

John

Frigidaire... | Answered on Oct 01, 2009


the previous owner was on lp gas, you are on natural gas. the orfice ratings are different. call a professional to convert the range back to natural gas.

Frigidaire... | Answered on Sep 29, 2009


Suspect a bad oven element. Worse case is a bad oven relay on the clock control board.

Frigidaire... | Answered on Sep 20, 2009


Approximately $200.00. Plus tax and shipping.

Frigidaire... | Answered on Sep 12, 2009


I run into this sometimes. Try this. Look at the timer on the panel. Cancle any time bake or clean comand thats set. When you do this, you should be able to unlock the door.
Please rate this solution

Frigidaire... | Answered on Aug 27, 2009


The top element normally operates only when you turn the temperature control all the up to the broil setting as it is the broiling element. If it doesn't work at the broil setting, suspect a bad brioler element or a faulty temperature control.

Frigidaire... | Answered on Aug 12, 2009


Check to see if the oven elements work, take out the racks and check if the black tubes on the top and bottom have ripped.

Frigidaire... | Answered on Aug 07, 2009


With the oven OFF, check the resistance of the bake element with a ohmmeter on the lowest scale. Rx1. If your reading is infinate, replace the element as most elements will open circuit when they burn out. They don't short out.

Frigidaire... | Answered on Jul 30, 2009


its the problem of over temprature sensor.its got shorted or got loose.so the machine is showing F3 error code on its display.check the sensor with continuity by refitting it. -------------- for how the sensor looks in shape click the link directly http://www.applianceaid.com/images/my-own-faultcodes.JPG you can get new sensor at www.repairclinic.com thanks.

Frigidaire... | Answered on Jul 13, 2009


get it cleaned

Frigidaire... | Answered on Jun 30, 2009


F90-Maximum oven door unlock time exceeded.
1. (F90, 91, 92, 93 & 94) Check the wiring between EOC & Lock Motor Micro Switch. 2. (F90, 91, 92, 93 & 94) Replace the Motor Door Latch assembly if necessary. 3. (F90, 91, 92, 93 & 94) Check for binding of the Latch Cam, Lock Motor Rod & Lock Motor Cam. 4. (F90, 91, 92, 93 & 94) Check to see if Lock Motor Coil is open. If open, repl;ace Lock Motor Assembly. 5. (F90, 91, 92, 93 & 94) Lock Motor continuosly runs - if Micro Switch is open, replace Lock Motor Assembly. 6. (F92, 93 & 94) Check oven door Light Switch - if open, replace Switch. 7. If all situations above do not solve probem, replace EOC.



Frigidaire... | Answered on Jun 17, 2009


Unplug the unit or flip the breaker switch (easier). After about 30 seconds, the latch will retract, allowing the door to close. Re-start the self-cleaning process.

Frigidaire... | Answered on Apr 21, 2009


Check the gap on the side of the door. Most likely the top will be wider than the bottom. There is a bulliten for several models. Call a service/parts dealer. Give them your model and serial number they can check the bulliten and order the correct hinge kit. The hinges and receivers will need to be replaced. Both must be replaced to correct problem. Not a difficult repair. If no one will hepl you, respond back and I can check the bulliten and get you a part number. And can order and ship you a part if necessary.

Frigidaire... | Answered on Apr 18, 2009


Your oven ignitor has gone out. This is located under the pan in the bottom of the oven. This is held in with 2 screws in the back portion of the pan. This will expose the ignitor and then 2 screws take it out. Replace this and this will fix it. very common problem

Frigidaire... | Answered on Mar 21, 2009


You can try turning the power off for a couple minutes then back on but this is typically caused by a stuck key or a faulty control board. Either way you're looking at needing a new control board.
Hope this helps.

Frigidaire... | Answered on Feb 10, 2009

Not finding what you are looking for?
Frigidaire Gallery GLEFM397DS Electric Kitchen Range Logo

137 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Kitchen Ranges Experts

Ismael Rodriguez...

Level 2 Expert

184 Answers

Paul Carew

Level 3 Expert

3428 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

Are you a Frigidaire Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Frigidaire Kitchen Ranges

  • Frigidaire Kitchen Ranges

Most Popular Question

frigidaire gallery glass stove top

  • Kitchen Ranges
Loading...