20 Most Recent Frigidaire Gallery GLEFM397DS Electric Kitchen Range - Page 2 Questions & Answers


You will need to replace the control board. Here is that part to order.

Frigidaire... | Answered on Apr 15, 2013


Hi Will Lawler - If the small element turns on but the large element does not, then more than likely, the range has a faulty burner or switch. If I was in your position, I would personally contact a professional for an accurate diagnosis and to assist with the repairs.

Frigidaire... | Answered on Mar 13, 2013


Hello jsorrell506 - I understand that you will like instructions on how to use the bake feature on your range. I found the manual and operating instructions on the Frigidaire website. Here is the manufacturer link and hope you find all the information that you need. I will recommend taking off the last letter of the model number so you can pull up the information.

http://b2b.frigidaire.com/support/manuals.asp?NewSearch=New+Search

Frigidaire... | Answered on Dec 21, 2012


Hello rdbal - Most bake and broiler elements are typically held into place with 4-6 screws or fit(s) in a bracket like connection and then needs to be screwed down. However every unit is different so please contact a professional to move accurately for more information due to safety and liability reasons.

Frigidaire... | Answered on Nov 15, 2012


Hi Ron - From what you have described if neither the burners nor oven turns on make sure the electrical connecting is 240V. The oven light and clock portions only required 115V. The clock and oven light working may indicate an electrical circuit breaker supplying the range is tripped or a fuse is blown. Confirm household circuit is correct and the range cord is properly wired to the terminal block.

Frigidaire... | Answered on Sep 19, 2012


Sounds like either the elements are bad, or the communication to the elements from the control board is now compromised.

Frigidaire... | Answered on Sep 04, 2012


The click is the relay so I would check the ignitor. If it is "open" replace it. If it "shorted" the valve is likely bad also.
Eric

Frigidaire... | Answered on Jan 09, 2012


Hello,

According to the Frigidaire website the place in Canada where parts can be obtained from is

Frigidiare Parts& Service
7075 Ordan Dr.
Mississauga,Onterio L5T 1K6
Tel# 905-565-9200


GENE

Frigidaire... | Answered on Sep 22, 2011


Hello,

The F3 error code means the the oven tempature sensor has shorted out and the sensor needs to be replaced. This is what the sensor looks likeoldtech2332_89.jpgTo check that it is shorted,unplug it and place meter leads at the plug on the end of it and see if the display on your meter shows 0.00 ohms of resistiance...if it does the sensor indeed has shorted out,a good normally working sensor shouls have a reading of between 1060-1100 ohms resistiance at room temp. a reading of ZERO means that the sensor has shorted and needs to be replaced. the part number for the sensor is 316490001 it could be purchased at your local appliance parts store or online at;
searspartsdirect.com
repairclinic.com
apdepot.com
partselect.com
apwagner.com

GENE

Frigidaire... | Answered on Sep 05, 2011


Hi,
If your electric oven is taking too long to heat or just not heating up right,then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101

Frigidaire... | Answered on Mar 15, 2011


Press clock button, then press temperature up button. Time will begin to change. When you have the correct time set, press the clock button again to save.

Frigidaire... | Answered on Mar 13, 2011


Hold the light switch closed on the oven and then push and hold cancel button after the oven cools.

Frigidaire... | Answered on Mar 09, 2011


press clean then up arrow for the amount of time. 3 hours is good for us.

Frigidaire... | Answered on Mar 01, 2011




Hi,


If your electric oven is taking too long to heat or just not heating up right, then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101


Frigidaire... | Answered on Feb 06, 2011


There is a regulator behind the bottom drawer remove the drawer.look in the back you will see a silver box that the oven fuel rail is on just below the rail there is a brass fitting that needs to be turned clockwise till it stops it can be hard to turn some times but turn it till there is no clearance between the nut part of the valve and the silver box then you can start your oven and it should work fine you can also adjust it to get a little more flame if needed.

Frigidaire... | Answered on Feb 03, 2011

Not finding what you are looking for?
Frigidaire Gallery GLEFM397DS Electric Kitchen Range Logo

137 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Kitchen Ranges Experts

Ismael Rodriguez...

Level 2 Expert

184 Answers

Paul Carew

Level 3 Expert

3428 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

Are you a Frigidaire Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Frigidaire Kitchen Ranges

  • Frigidaire Kitchen Ranges

Most Popular Question

frigidaire gallery glass stove top

  • Kitchen Ranges
Loading...