20 Most Recent Krups KM7000 - Page 7 Questions & Answers

The heat sensor on the boiler is not detecting any temperature change. It could be a wire or terminal off. The sensor is right at the front of the boiler. If the sensor is faulty it means a new boiler because it's stuck on in the factory.

Error 9 is only related to the NTC on the front of the thermobloc. That's the wires, terminals or the resistor on the NTC that changes value with heat.

https://www.ebay.com/itm/183294828306?ViewItem=&item=183294828306 krups optisteam plus owner manual steamer recipes pdf user model 649 652...

Krups have their own cleaning tablets and descaling powder, your local Krups agent should be able to help you.

You need to supply model number as well as the code.

Krups Optisteam Food Steamer with manual was for sale on ebay with a manual, but is no longer available. https://www.ebay.com.sg/itm/Krups-Food-Steamer-Optisteam-649-With-Manuals/123088622624

Error code 01 accompanied by that noise points at the distributor being faulty. The distributor is the electronic tap that directs water to the ram to compress the grounds in the boiler and then redirects it to the brewing chamber to make the coffee, then to steam, then to rinse. It's the sort of item you just replace because it's quite a large job to change it anyway, not the sort of repair you want to be doing over and over trying not to spend money on the part.

OA means that the sensor is not detecting any heat in the boiler. That means either the boiler is not heating or the sensor or sensor wire is detached from the boiler or the sensor has failed. The sensor is located behind the front display panel stuck in the front of the boiler and it has 2 thin wires in it with push on terminals.

The valve in the lid is faulty, it will eventually fail completely. The correct lid can be ordered from your local Krups service agent. Be prepared for disappointment though as many of them are now obsolete. You will need to give the agent the model number, it's normally on a sticker on under the base.

PDF version for sale online: krups optisteam plus owner manual steamer recipes pdf user model 649 652...

O sensor de temperatura na parte frontal da carca?a da caldeira (atr?s do painel frontal) n?o est? detectando nenhum calor na caldeira. Freq?entemente ? o borne de terminal desconectado do sensor ou o sensor inteiro n?o est? mais preso na caldeira. A solu??o da Krups ? para substituir a caldeira completa, mas no passado, eu revendi o terminal de volta ou colei (com cola resistente ao calor) o sensor de volta para a caldeira.

A common place for a leak under the machine is the barista seal that goes in the bottom of the boiler around that eject rod. Barista seal part number is MS5002202, Seals on the tamping piston are MS5002040 (there can be 1 or 2 of these piston seals) If fixing the leaks does not fix error 6 then I expect it will end up being the distributor. Part number MS2A01500

Did you completely finish the descale process. On the models I'm familiar with you run thru the descale doing every step it requests then refill the tank and run thru the rinsing process until it ends completely. As far as I know there is no reset for errors, the problem needs to be located and fixed. I have no idea what the unplug icon may be indicating.

Probably going to depend on the model, ask another question and include the model number in the subject line to attract maximum attention