20 Most Recent
DeLonghi Esclusivo Magnifica ESAM3300 Espresso Machine - Page 4 Questions & Answers
Sometimes the pucks do not fall into removable container. How do I fix this?
Make sure the swinging arm at the top of the brew unit moves easily. Check nothing on the brew unit is damaged. Servicing the brew unit might help.Brew Unit
The transmission can wear out prematurely due to the brew unit becoming
stiff. The piston in the brew unit should move smoothly and fairly
easily. Keep the brew unit in good service by occasionally removing the
piston to clean and re-grease the two big red o-rings using a food-safe
grease. To pop the piston out the top, gently remove the plastic u-clip
from the base of the shaft underneath, paying attention to which way up
it goes for reassembly.
4/3/2014 12:02:45 PM •
DeLonghi...
•
Answered
on Apr 03, 2014
Why does my DeLonghi not turn on?
Hi, ring delonghi support, very good advise, and if they cant give you a solution then they will tell you who in your area will fix it, hope this helps
3/21/2014 10:02:22 PM •
DeLonghi...
•
Answered
on Mar 21, 2014
The power went out while i was cleaning. now both
hi check u havent snapped the switch prodder ..its on the bucket rear .bottom..... change the wast bucket if broken. if its there still u may have a problem with the pcb .. we carry out repair service anywere we do a postal service
3/17/2014 1:38:00 PM •
DeLonghi...
•
Answered
on Mar 17, 2014
How to replace Delonghi magnifica
ha this is the same problem i had just last week at a customers house with the same machine , the knob does pull off but it is hellish tight and you feel like the valve is about to burst through the front of the machine but it does pull off, when fitting the new knob it is a good idea to put some grease over the shaft before pushing the new knob on as it's nearly as hard pushing the new one back on as taking the old one off.
regards
Ian
2/12/2014 3:08:31 AM •
DeLonghi...
•
Answered
on Feb 12, 2014
Impossible to remove infuser, appears to be jammed
Plug in Machine. Turn on for 10 seconds or so. Turn off. Let Machine turn itself off completely. Once it is quiet, do not unplug, try to remove the infuser. It worked for me (procedure recommended by customer service for Delonghi in Switzerland).
1/1/2014 10:34:52 AM •
DeLonghi...
•
Answered
on Jan 01, 2014
My machine leaks
Your O rings may need replacing. Remove the back and side panels from your machine with a Phillips screwdriver. Look for signs of leaking near the hose connectors. Remove the leaking connectors by expanding the wire clamp with needle nose pliers. Home Depot has a good O ring selection.
10/21/2013 6:48:50 PM •
DeLonghi...
•
Answered
on Oct 21, 2013
Not finding what you are looking for?