20 Most Recent
Saeco Odea Giro Plus Coffee Maker - Page 9 Questions & Answers
Red ! flashes constantly
The lube is for the o-rings on the brew unit, and the ones on the white plastic valve behind the brew unit. As for the light there might be something a little coffee grounds keeping the door open.
Machine stoppped working
Try this remove the brew unit and clean the screen on the unit, then insert unit, and open steam/hot water valve to prime. If that does not work then there might be a malfunction with the pump, I am assuming that the machine is only 2 weeks old?
Saeco Odea Giro - alarm light continually slow flashing
I had the same problem. I filled everything up and closed it then took the hopper top and placed a small magnet that fit the circumference of the hopper sensor (I took one off of a refrigerator magnet and it fit down into the sensor) and it immediately went green. Hope it works for you.
Seaco Giro Quick Flashing Red Alarm
Bypass the door interlock with a magnet (the red light will go out when you have the magnet correctly placed above the group). Brew a cup and watch to see how the water is getting into the hopper. Once you know how it is getting into the hopper it should be relatively easy to determine how to fix it.
No instruction manuel
If you google for this model followed by the word "manual" then a link to espressotec's online manual will come up.
Good luck.
Water line on intermittent flash after trying to clear the steam
I was able to fix the problem after reading your post.
I had lost my manual and found a copy of the instruction manual online.
http://www.espressoitalia.com.au/viewStory/Coffee%20Machine%20Manuals
I read the instructions for de-scaling (page 15) and followed it EXACTLY the way it instructed me to.
The entire process took roughly 2.5-3 hours. I set an alarm to remind me to re-dispense the solution again (for 15 seconds) every 10 minutes.
I'm not sure if you skipped a few steps(I did the first time I went through it). If anything, the trick might be to hold the hot water button for 6 seconds to disable the de-scaling alarm.
Your de-scaling alarm probably hasn't been de-activated. ( To make sure I held the hot water button for about 15 seconds)
I purchased a second hand
try inserting the frother in hot water its probably block and for our water everytime you whant steam open vale boiler start to boil water let the water drip into the tray wait untill steam come out pierre
How can we clean our saeco pot.
White vinegar will work well. After you run the vinegar through, run about 2 pot of water through it to rinse. This should do the trick.
Saeco Odea Giro tuning on/off
turn off each night and when going away! the machine will last longer.. without repair! also saves money (they use alot of power!
PLEASE tell me how I
Hi and welcome back to FixYa,
I emailed the Community Manager to attend to your request/concern.
Good luck and Thank you for using FixYa.
Brew Group will not reset
Hi Neil,
Try to put the dregsbox and driptray on place, close the door and turn on the machine.
When the machine stop again, open the door and put the brewing unit on place.
Best regards
/Mirran
Not finding what you are looking for?