20 Most Recent Saeco Odea Giro Plus Coffee Maker - Page 3 Questions & Answers

I don't believe you can. There is a switch that turns off the grinder if you remove the lid to the bean hopper. The grinder adjustment is under that lid...so, unless you bypass the switch in the lid (which can be done) you cannot get access to the grinder adjustment. -doc

The coffee dispensing valve is available at your saeco dealer 1-2 hr job to change...

I had a similar problem Mine was caused by an "oily" type of coffee beans. Grind was accumulating in the grinder. I did open the machine and cleaned the grinder physically. At least, try to remove all beans and sucked with a vacuum the interior of the grinder screw. Good luck

Press about 6 seconds the steam button (on the right side).

Hi Some machines have a mind of their own. Take a look there. Free User Manuals and Owners Guides ManualsOnline com One thing though from my experience is that when I have pushed too many buttons some things may not work properly, then I disconnect and wait. Sometimes it helps, kolbrun

Usually the coffee sensor has 2 magnets that gets dirty with the lubricating material.You have to clean the 2 sensors and the machine will check again the rotation or the grinter and start working again !!!

Martin Try to clean the water flow sensor See more diagnostic option in the following picture you should see the pump flow meter light in pulses - if not check / clean the flowmeter and its contacts / connector see more diagnostic in chapter 5.1.1 of the service manual can be founed in the following link http://www.partsguru.com/user/SERVICE%20MANUAL%20TALEA%20ODEA%20REV.03%202.pdf

Hi, open the steam/hotwater outlet while its heating. It allows the air to release and water to fill the void. Dazza. Enjoy your coffee

Try different electrical outlet

The turbine flow meters contacts are corroded, or the turbine itself is broken.