20 Most Recent
Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher - Page 5 Questions & Answers
No indicator lights Whirlpool wdt710paym dishwasher
If it doesn't run and you have no indicator lights, check the circuit breaker for that outlet. If it is ok, test the output voltage at the plug-in for the machine (115Vac). If it is "live" then check inside the control panel (turn off the breaker first) for a fuse that appears blown. If no fuse problem, CAREFULLY (with breaker back on) see if the main switch is getting power. If it is getting power, the control board is shot...replace it!
Control clean light keeps blinking and dishwasher
Your dishwasher will do this as a safety in case the element is broken and feeding electrical current into the water. Sometimes just a false reading.
Reset your console by pressing: high temp wash, heated dry, high temp wash, heated dry
When all the lights are on you are set in diagnostic mode. Just hit cancel a you will be able to run your dishwasher as normal.
If this same light appears again then you have a bad element or thermostat.
The dishwasher stops in the middle of the wash
faulty or loose door safety switch,,,check for mounting screws loose,,or wear on door catch,,if not loose or wear,,faulty switch,,replace.
Microwave over oven starts but turns off in a few seconds when oven is hot.
Likely thermal shutdown. Insulation may be missing or out of place between microwave and the oven itself. If you see foil, that is radiant barrier, and if it is damaged, it raise the temps in the microwave cabinet enough to cause this.This assumes no arcing or other audible or visible issues and microwave just "drops out".
Not finding what you are looking for?