Top 20 LG LDF8812 Stainless Steel Built-in Dishwasher - Page 9 Questions & Answers

I would remove the back panel and the cord and clean up.Probaly electrical back their is caked with mud,not letting it get a good connection,take out side and spray down with a garden hose.

I use repair clinic dot com all the time to trouble shoot. have model number and make ready. good luck.

I do not know which machine you have , but it sounds like the plastic catch on the dispenser has worn down. You would need to replace the dispenser unit.

E1 Leakage error. Cause : water leakage in hose connections. Water is leaked by damages.

LG has a good factory website. See whats there in the info downloads.

Plain answer: NO

Do you mean"Can you run a machine on salt water" then my first answer would be "NO". Salt water is highly aggressive and the machine will fail in hours. If you mean, can I use a salt additive then consult your owners handbook. Salt additives are used to get glassware clean.

An OE error code suggests that you have a drainage problem with the unit. Check for drain blockages.

Try some of these sites on line Sears Parts V & V appliance parts Repair clinic Marcone Appliance parts

This is the fix for the oE error code.
https://m.youtube.com/watch?v=V04PvdyWVTM

The display and control board seems to be faulty.

Try MFG customer service or google make model or try: http://www.manualslib.com/

The problem could be the washer motor bearing. LG motors have the impeller unit coupled to the motor and the water seal between the motor and impeller is a problem. The drop of water that leaks ends up on the bearing and it eventually gives problems. This can be seen by close inspection of the front bearing for slight rust indications .They use poor quality bearings but replacing the bearing is easy BUT you need to replace the water seal as this is the cause of the problem. Unfortunately the water seal is part of the plastic impeller unit and must be replaced. Not necessary to replace the whole motor as the bearing is easily replace and cheap. (the noise made by this fault is more of a slightly high pitch grinding / whine)

Oh, that's a bad sign. You might be able to fix the problem by replacing the diverter motor (and putting some silicon grease or silicon seal) on the mating surfaces. In more extreme cases, where the leaking water has damaged other parts, it may be necessary to replace the whole pump/sump/motor assembly, and maybe the wiring harness if the water has damaged or corroded the connectors. If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

push and hold any two buttons until you hear a beep or at least 20 seconds,.Adrian......

The circulation pump is faulty, mainly caused by water entering into the pump bearing through defective water seals. The pump cannot be repaired and needs replacing.

from what I can work out this is related to measurement of the flow and water levels, check all hoses etc for any build up and make sure they are clean. http://answers.lg.com/answers/7676/product/MD00000191/lg-electronics-ldf6920st-questions-answers/questions.htm

The E1 or 1E error or fault code indicates that the washer is not filling with water. Check to be sure the water supply valves are open. Also, check to be sure the water supply hoses aren't kinked or clogged. Next, remove the hoses from the washing machine and run water into a bucket to test the pressure and flow of the water. If all of these check out and you have good water pressure and flow to the machine, you should replace the water inlet valve.

Which model Lg do you have?

On LG's, a 1E error message usually means there is a problem with the water inlet valve. Check your shutoff valve under the sink, first, just to make sure someone didn't accidentally turn it off. If it's on, then it's most likely the water inlet valve located under the dishwasher.