20 Most Recent
LG LDF8812 Stainless Steel Built-in Dishwasher - Page 9 Questions & Answers
I have an LG dishwasher,
I've just solved the same problem on my 2120. It started when the pump motor bearing failed and continued after I'd replaced the bearing. According to my handbook the E1 fault is theoretically a water leak but practically it is that the pump is not delivering enough water. In this case the failed bearing had allowed the shaft to wobble about and damage either the rotor or the inside of the pump (it's sealed so you can't strip it). Solution was to replace the pump.
Paul H
What does it mean when
Guy , you're all right except for one detail. You must think as the machine does. The machine "thinks" the water level is to high, it is not necessarly. I got a FE error on a LDS5540ST and the problem was simply the floats that activate the limit switch that monitor the water level. The module was simply ful of normal mud-junk-scrap that you would normaly excpet in any dishwasher. Simply open the float module , wash the junk , Voila. Cost 0$
Not finding what you are looking for?