20 Most Recent
Sony BRAVIA KDL-40V3000 Television - Page 8 Questions & Answers
New tv and hdmi
COULD BE A BAD HDMI CABLE,,ALSO TRY CONVERSION IN THE SETUP MENU ,,IT MGHT FIX THE COLORS AND THE LINES
I have a 4 month old sony bravia 1080 120mhz Sony
Not common but electronics are electronics , we can have failures right out of the box. Generally Sony is reliable and I must say that you should not have to worry about cost , Is it not under warranty - its only 4 months old !!
Stand-by light flashing. No picture
This is bad the 13 blinks is a display issue. To repair your set you have to get a panel.. CALL SONY and raise hell.. I have seen this repaired by sony even after there factory warranty was up. Price of a panel is like 5 grand.
Screen goes blank / black, sound still works
It sounds like your LCD Screen is no longer working. I would try contacting Sony and ask for a refund. I had the same T.V and the LCD Screen had gone out. A techniction came out and Condemned the screen and i had to pay $500 for a new T.V.
Half the screen is black
I think its either the X-sus or Y-Sus Boards which control the display. These are 2 boards with heatsinks on them, lots of capacitors and are at either edge of the screen.
Can't get audio via optical port.
ok, i think the problem lies with the tv, there must be a setting in the sound menu to use optical as sound out, as the sound will be via the HDMI cable, i applogise if you have checked this.
Out of range
You likely have the screen refresh rates on the PC set too high. The Sony will only accpet screen refresh rates of 60 Hertz. Checkl the settings of the display in your control panel..
Green pixel lines
It sounds like a bad LCD panel but you would have to post a picture of the problem for me to be sure
I have a new Sony
It is your BE2 Board, it has a problem, iv seen this befor, if it is brand new, i would call sony, they should send out a service center, and Sony will cover the repair
Sony KDL-40V3000
Sorry to hear this, It looks like you have a bad panel, more specifically a bad t-con board but this board is supplied as part of the panel. The panel for you tv costs over $1000, If I were in your shoes I would call sony and complain, they have been knowen to assist you in some way IE pay for the part and you pay labor or sometimes they take care of the job in full. They are going to want an estimate from an authorized service center in your area. You may want to have one come out and write you up an est and then call sony and complain. Let me know if you need more info.
Thanks
Tim
Sony baravia
Hi
the meaning of two blinks from the self diagnosis function is
Two blinks - B+ over current protection (OCP), unit goes to the standby mode then displays the 2 blink fault. Could be a short in the power supply of any of the circuits.
Not finding what you are looking for?