20 Most Recent
Proscan 42LA30H 42 in. LCD Television - Page 5 Questions & Answers
No picture but sound on my proscan
Check its speaker first. If it is OK, check and replace damaged component/s at its audio amplifier section circuit. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
https://elektrotricks.blogspot.com/
faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent. Search the site by type in the brand name and model of your set, in its search bar at the right side column, and press enter.
3/3/2021 2:57:10 PM •
Proscan...
•
Answered
on Mar 03, 2021
How to use service port on a proscan tv
I have a proscan tv and i tried connecting a usb cable to the usb service port, and nothing has showed on the menu options and nothing on the source menu... Is the service port any use?
9/10/2019 10:50:53 PM •
Proscan...
•
Answered
on Sep 10, 2019
My proscan has sound but no picture what is the problem
After turning off the power, disconnect everything from the power outlets or surge protector. Wait for several minutes while all residual power exits the system. Return all the devices to power and turn everything back on. Check the television to determine whether it works properly
9/7/2019 4:53:13 PM •
Proscan...
•
Answered
on Sep 07, 2019
Want to hook up an external antenna but am unsure of the TV configuration. I have settings of TV; AV, Svideo; YPbPr and PC. have settings such as STD; AIR; HRC and ?. What are the correct setting
You need to connect the coaxial cable from the antenna to the TV's coaxial RF (TV) connection. (Really old antennas may need a signal adapter - 300 Ohm to 75 Ohm.) Then make sure that the current video source (sometimes labeled Input) is set to TV. On the later Proscan PLED1526A, there is an Input button on both the TV and the remote to cycle through the list of video source options. Enter the menu of the TV (on screen display). Now you should be able to find a sub-menu for setting the channel information. Using the newer model above, you may have a Channel option. Use the left/right arrows to reach that. Then press the Enter to enter the sub-menu. Navigate to Signal Type with the up/down arrows and set this to Air for over the air channels. (Use the left/right arrows to select the signal type and press Enter.) I believe the HRC is for certain cable systems. Then try the Auto Channel Search.
Note: if the TV was manufactured before 2007, it may only have a NTSC tuner. In that case, you'll need a set-top OTA converter box (ATSC to NTSC) to get most channels. Only low-power stations are still broadcasting the NTSC signals. Depending on the model, you can connect this to the RF port of the TV or the AV (composite video) or the YPbPr (component video) source with the appropriate cables. Change the TV input as needed. Then scan for channels following the directions for the converter box.
I hope this helps.
Cindy Wells
7/22/2019 6:37:48 PM •
Proscan...
•
Answered
on Jul 22, 2019
I need to reset Proscan PLEDV 3282A TV TO FACTORY SETTINGS
that happens, you can force your TV to reset by following these steps:
- Using a straightened paper clip or ball-point pen, press and hold the recessed RESET button on your TV connector panel.
- Continue to hold the RESET button for approximately 15 seconds
6/14/2019 11:36:43 PM •
Proscan...
•
Answered
on Jun 14, 2019
Not finding what you are looking for?