20 Most Recent Onkyo TX-SR605 Receiver - Page 3 Questions & Answers

Zone output.

I would do a factory reset first. ONKYO AVR AV Home Cinema Receiver Factory Reset

do you have a center channel speaker hooked up? Most dialogue in movies should come from the center channel.

Check on the back panel for a fuse. Usually a black knob with a curved arrow going 1/2 circle. push in and turn counter-clock wise or unscrew to release the fuse. Hopefully it has one like that. Easy to get to. Hope it has that, if not...idk. Oh yea, don't go by eye determining if its good or not, use a multi-tester to know for sure.

I'll second what dennisae said. I've got a TX-NR708 that had all sorts of video issues after about 6 months of use until I got the HDMI board replaced. This seems to be an issue with this brand over a wide number of models.

I would try a new HDMI cable that has the gold plated ends for higher resolutions. Some of the older non-plated HDMI cables seem to have difficulty with higher res DVD's. This is applicable especially to Blu-rays vs plain DVD's.

Hi mick

the unit has a voltage selector switch on the rear. Have you selected the 220v option. this will solve your need for a reduction transformer. If you have just gone ahead and fired it up in 110volt settings.... internal damage may have already occurred.

What is the switch set to now? Let me know

regards
Graeme

How do I reset my amp / receiver from protect mode ?

You will need to contact Onkyo directly and request the board from the parts department. I was not able to locate a part number for this as we are usually requested to perform component level repairs for these units.

Dan

This is not normal, if you are using an entertainment centre, air flow is very important, 3" to 6" clearance on sides, back should be open, units should not be stacked. If that is not the issue, how many speakers are you running? if they are the proper numbers and they are matched, that is good.

just pick from here

http://www.google.com.au/search?hl=en&q=toshiba+dvd+remote+control+codes&meta=

you may not find the exact one but the basic functionality for dvds should work.

LOCATION R3910 SHOULD BE CHANGED TO 10 OHM 1 WATT ON POWER SUPPLY BOARD LOC. NUMBER IS U37