20 Most Recent
Frigidaire 30 in. Electric Gallery Series Self-Cleaning Double Wall Oven - Page 5 Questions & Answers
Frigidaire gallery series self cleaning
Hi,
I think we can fix this, it sounds like it is stuck in Celsius mode.
To tell if the display is set for Fahrenheit or Celsius press
BROIL and hold it for 6 seconds; “550°” will appear
and “BROIL” will flash in the display and a beep will
sound. If “FAhrnht” appears, the display is set to show
temperatures in Fahrenheit. If “CELSIUS” appears, the
display is set to show temperatures in Celsius.
2. Press SELF CLEAN to switch between Fahrenheit or
Celsius display modes. The display will show either
“FAhrnht” or “CELSIUS”.
3. Press START to accept the change or press CANCEL
to reject the change.
Let me know if this works
My electrolux premier cooker oven isnt working
Check to make sure that the circuit breaker/gfi is not flipped for the oven. Push the switch all the way to off and then on again. If the power goes off again, this indicates a short, which is very dangerous.
If you already checked this and the power does not come on, make sure the breaker is set to off and pull the oven and check the cord and plug for any sign of fraying, loose wires, blacked areas, etc.
Since this is 240v, I would not recommend going beyond these basic instructions. If you feel confident to remove the panel to run some electrical tests, please post comments and we will help you do that.
I opened the door while cleaning was in setup and
Hello, welcome to Fixya.
The timer is just indicating the "monitor" switches where interrupted while the sensing of their position was taking place.
Have you tried turning off your breaker at the home service panel ( or unplugging it for several minutes ) ?
If not, turn off your breaker and turn it back on. This should initiate a restart of the component`s back to factory default including the lock monitor switches.
Once you switch the breaker, allow it to go through the start-up process ( don`t open the door or touch the clock ) where the processor (onboard watchdog) checks to make sure all functions are in working order and all switches are in the default position, ready to use.
If it works for you please take a second and rate the answer favorably, if not let me know and we`ll go from there.
good luck
macmarkus :)
Unlock double oven
the unit should unlock by itself after it has cooled down if not try and hold the clear off key for 3-5 seconds pushing in o nthe door at the same time sshould unlock them
The self cleaning instructions for my Frigidaire
Hello- The function is automatic when clean button is pushed. Oven will lock, and turn on at full power for about 90 mins. This 'feature' can, and usually does eventually burn out circuits in the control board. Techs call this the 'self-destruct' option, cheerfully promoted by the salesman. Avoid using 'self clean'! Scrape and clean with light soap/water. Turn on to 450deg. for about 30 min. This is about half the temp. of a 900deg. 'clean' cycle and a lot less expensive in the long run. Please acknowledge this post if info is helpful- have more if needed.- Thanks- Ed
Oven won't get hot
If your oven still uses a pilot light, it also probably has a thermocouple positioned in the pilot's flame path to detect whether if is safe to turn on the main burner.
When the thermocouple fails, the oven thinks the pilot light is not lit and will not let gas flow to the primary burners.
The part isn't costly (should be <$20 US) but replacing it may require some expensive labor.
GLEB30T8CBA Frigidaire Double Oven
the relay is common for both the bake/broil elements
Changing a basic bake element.
disconnect power first!
1) Remove oven racks, remove the mounting screws from the element mounting plate, found against the back wall of the range oven liner.
2) Pull defective element away from the back of the oven wall as far as the wire will allow ( the odd time, the wires may be too short and you may have to disconnect the wires from the element at the back of the range ).
3) Remove wire lead screws from the element.
4) Replace the element and reconnect the leads ( if only two wires going to the element, it does not matter which goes on left or right wire terminal ).
5) Tuck surplus wire behind insulation.
6) Line up holes and reinstall new element using existing screw.
to get the instructions on relay location and replacement procedure.please click on the above link directly
http://www.applianceaid.com/trorelay.html
This will help. Thanks please keep updated.please do rate the solution
if helped.thank you for using fixya.
Main top crack
Hi jerseyfol58,
Hate to say it, but yes. The entire "ceran top" comes as a whole, with the exception of the burner`s.
You might consider purchasing the top but having a pro install it, it is quite involved.
Hope that answer`s your inquiry.
Good luck.
macmarkus :)
Not finding what you are looking for?