20 Most Recent Mitsubishi WD-65833 65" HDTV - Page 8 Questions & Answers

these white spots are caused by a bad DMD chip call Mitsubishi and they will find a servicer and send the part to them for repair. You will only have to pay the labor

Does the satellite receiver power up? Usually they go through a test sequence when trying to reconnect, i.e., there is some picture output to the TV even when a satellite is unavailable. Did the input on the TV get changed? Try cycling through all the inputs. Do you have any other video devices, like a BlueRay or DVD player? Do they work? Divide and conquer, figure out what does work, then look deeper into what does not.

If you wish to get some details; check the site linked here. Pull up older posts.Surf the site with patience.http://electronicshelponline.blogspot.com/

Set it to default. Color temperature has no effect with the wattage output to its bulb. Electro help

Put it back to the mid point of it's adjustment range. If the V hold won't stop the picture rolling at some point in its adjustment range then the circuit that it affects has drifted out of tolerance. The defective parts in that circuit need to be replaced..

Put it back to the mid point of it's adjustment range. If the V hold won't stop the picture rolling at some point in its adjustment range then the circuit that it affects has drifted out of tolerance. The defective parts in that circuit need to be replaced.

Your Vertcal Hold Problem Is Due To Lack O f( Sync) Hold Which Is Usually Caused By Defective Filtering In The Vertical Output Circuit

Lamp or color wheel bad will cause TV to completely shut off and turn on 3 times , then stay off.

there may be display problem

It sounds like you need to re-adjust your convergence. The purpose of adjusting your convergence is to align your red, green, and blue colors. Moving your TV often causes this problem. I hope you get it going.

Service Manual Mitsubishi Projection TV Chassis V20A Mitsubishi WS 65807 Error Code 22 Short Protection