Top 20 Mitsubishi WD-65733 65" HDTV Questions & Answers

Try this repair site to get the error codes. https://www.youtube.com/watch?v=INird71KKtA

How old is your TV, what is the make and model?

i`m afraid isn`t sold separatly.

If you get no television on the screen and the red light is on then I would replace the bulb should fix the issue.

sounds like a bad color wheel

Cut a big hole in the back of that piece of junk, or take it back.

What do you think should be right. If there any loose solder terminals to the ballast bard, this type of fault can occur. Anyway, I'm not sure about it; but check this frist before doing any other. Gopakumar Gopalan Google

I'd just replace my lamp just three days ago and the problem still exsist

Yes, it's very common with this television and they should cover it under warranty.

Bad optical light engine, most expensive part in set

this sounds like a bad optical light engine, the spots will only continue to grow in number. See typical engine for this brand, lens on left is where image comes out and is directed on the screen.

that part number is for the Lamp assembly. How can I assist you with your set. Please respond to this same post for further assistance.

It is probably the wiring. Try buying a new power cord.If not than it is just malfunctioned.Contact Mistubishhttp://www.mitsubishi-tv.com/contact

You need to replace your DLP chip located on your DMD board. You can buy the chip from shopjimmy.com for $160. Shop Jimmy also has a video that shows a step by step process to change it out yourself. I changed mine in 11/2 hours and my tv is like new. Make sure the new chip is placed perfectly square or your picture will be skewed, not the viewing picture, just printed media and it will drive you crazy. I know, I did it and had to take it apart and adjust my chip. Twice. Or, you can call mitsubishi.com and for $208 they will send a local tech to your house to fix it for you. I enjoyed the challenge. It wasn't hard. Good luck.

Possible lamp but: Mitsubishi TV troubleshooting Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold down the Device and Menu buttons together for about 5 seconds. The Power light will start to flash in a two digit sequence. For example, 3 flashes, then 7 flashes = 37. Here are the error codes, and the corresponding problem: 12 = No error detected, check power supply. 32 = Lamp Cover is open. 33 = Air filter cover is open. 34 = Lamp abnormality 36 = Light Engine (DMD or Lamp Fan stopped) 37 = Exhaust or Lamp Ballast Fan stopped 38 = Lamp Temperature High 39 = DMD Temperature High 41 = Short is detected 44 = DVI cable between FMT and Engine disconnected

im pretty sure the light fuse has exploded inside your tv. itll be cheaper to buy a new one

Colorwheel eeds replacement most likley it could also be a fan but I would assume its the colorwheel especially if it was real highpitched sort of squealing sound. You can get the colorwheel and free tech assistance from the guys over at www.tvrepairworld.com

DMD CHIP NEEDS REPLACED

Check this possible answer I provided and it worked for another similar set:http://www.fixya.com/support/t12296849-turns_off_shortly_after_turn?mt_f=viewFull162

Yes,replaced it with another brand new lamp the same exactly as the original lamp was inside the tv when it was purchase,if u still have the same problems.Then ur tv the main projection unit is defective.This kind of problems,than the tv it is not worth repairing.Because the CPU projection unit cost about 70% of the tv.