20 Most Recent LG WM2455 Front Load Washer - Page 5 Questions & Answers

Make sure the drain hose is not plugged by lowering the end below any water in the machine--it should flow out freely. If ok, look carefully at the filter housing for any warping or cracking of the plastic lid or case. Make sure the clamp fits tightly. If water does not flow from the drain hose properly, try 'back-washing' the filter element--you may have to replace it if you have difficulty.

Whats even more mundane ,this plays havoc on the electronics and specifically the expensive control board.Opt for extended warranty coverages!

are ther brown stains if so the bearings are faulty.

Hi. this is a failed timer device. simply replacing the timer control module will eliminate these issues you are having.

rate me

just open the door on your lg and the serial number is on a tag.

It should have adjustable feet with rubber pads to prevent it from walking.

first try unplugging and waiting a minute and then plug in and see if that resets it. if it does not try unplugging, wait a minute, hold power button in for 15 secs and then plug back in and see if that resets it. and finally, try the second one and continue to hold power button in while plugging back in. all are different ways of resetting some washer models. one might work for you and cannot hurt to try. good luck

This dE error or fault code to indicate that the door is not latching properly. Check the lid or door operation to be sure it's not binding and that the door alignment is correct. Also, check the door/lid hinges to be sure they're not binding. Finally, make sure the door catch is in place and not broken. You may need to replace the door hook/catch or the door lock assembly.

its best to get an engineer to the problem as it could be anything at all or just an alignment problem eric

Sounds like the dial timer is defective, I am not affiliated with this site, https://www.repairclinic.com/Video

http://www.lg.com/au/support/support-product/lg-WT-H9556

https://electronicshelponline.blogspot.com/ http://homenol.blogspot.com/ Visit this site to get some details.

Remove the screws that attach the top panel at the back of the machine, slide the top backwards and remove the top panel. Run the machine as per normal, but be careful as the electrics will now be exposed, you will be able to see where the water is leaking from and be able to repair/replace defective part.

If you wish to get some details; check the site linked here. Pull up older posts........ http://electro-medical.blogspot.com/

take the back off see if the water pump making that noise or is broken should look something like this one