20 Most Recent
Krups Small Appliances Espresso Machine - Page 2 Questions & Answers
Error code 10
You could try giving us a model number, there is more than one Krups Espresso maker. One error code 10 that springs to mind is either not heating or the sensor that detects the heat is detached, broken or disconnected.
Code 12 krups
There was no ejection switch pulse during 2x empty cycles. Inspect the switch or what activates the switch, check the wiring to the switch and PCB. Is the chamber clogged with grinds.
Krups 8025
Yes the distributor is the most likely cause, if you have done the O rings in the hydraulic ram assy you should be capable of changing the distributor. The only other thing I have seen dump water to the tray is the valve on the end of the pump with the hose going back to the tray. You can pull the hose off at the tray end and run the machine to determine if that's where it's coming from. It won't be easy. I have an outer housing with lots of cutouts so I can observe inside while it's running.
Why wont krups light wont go off
This solution assumes you are trying to turn it off and it won't.
If it is a model like in the photo it could be as simple as a switch button, does it seem a bit looser than normal? If it's not that you may need to change the pcb on the left hand side.
If this solution does not help give some thought to supplying a model number and spend a bit more effort describing the fault.
Switch problem
Hi Porl, my answer was assuming that your machine is the product in the picture, if your machine looks nothing like the picture then ignore my answer. It is not easy to answer questions when no specific model information is supplied.
XP7240 not draining properly
Replace that pressure valve and also inspect it for leaks from directly under the boiler, from that pressure valve and from the top of the hydraulic ram. If when you buy your valve you find the white housing will not fit where the old one came from you can just use the piston into your old housing. Check this before removing the hose clip from your old piston housing. If your old piston housing is leaking badly before you even do this job then you will need to replace the whole distributor as sometimes a piston housing retaining lug can fracture, there are 3 of them and they are part of the distributor.
Not finding what you are looking for?