20 Most Recent Jenn-Air JED8430 Electric Cooktop - Page 4 Questions & Answers


Yes, Red and Black are supposed to be your Load wires (110) each then green for ground which should be white..Before I wire it up use a tester and make sure that is what is going on.

Jenn-Air JED8430... | Answered on Jan 08, 2012


the only way is to block off/check the flapper., if your not going to use for the winter you can disconnect the vent from under the cabinet temporaily and close off there till you can gain access to check outside grill

Jenn-Air JED8430... | Answered on Jan 05, 2012


First, you have to pull out the cooktop from the counter and remove the knobs.
Next, there are hex screws around the perimeter - do not remove the lowest ones on the front and the back (they hold the tray that the burners sit in) or the ones on the bottom (they help to hold on the blower assembly).
The final trick are two screws that are located in the downdraft plenum - there's one on each side (you don't have to remove the two in the back or the front - those are for small covers only).
The glass should lift out.
When putting the new glass in, remember that the plenum walls fit on the inside of the glass (you won't see the top of the steel).

Jenn-Air JED8430... | Answered on Dec 16, 2011


Hello, Thank You for using FixYa. I will be helping you today.You have to lift the unit up from the counter use some boards across the counter to support it and remove the screws from around the unit under the glass lip. On some units there are screws under the vent grille also. After removing the screws lift the whole top off.Thats all you have to do.
Thank You and please rate my answer if it was helpful..

Jenn-Air JED8430... | Answered on Nov 12, 2011


Hi I have changed out the maytag and it takes a little time but it is easy to do ,
but costley, First of all turn off power or unplug unit, open the front of this unit and you will see to small screws top left and top right side, after removing the two screws then lift the top from the front, then all the wires will be visable to you, if you are not able to remember all the wires where there go then mark wires with masking tape or you can take a picture if you have a camara that you can use . like i said it is easy fix just take your time >

Jenn-Air JED8430... | Answered on Oct 28, 2011


This means the oven lock is activated. The cook top touch panel is likely causing some problem.
Try to press the child lock button and see if F1 goes off. Otherwise the control panel will need to be replaced.

Jenn-Air JED8430... | Answered on Oct 21, 2011


Hello,

240 volts,8,300 watts would calculate to amp draw of 34.5 amps and thusly a 40 or 50 amp circuit is reccomended


GENE

Jenn-Air JED8430... | Answered on Oct 16, 2011


Yes you can. Call Jenn Air ((877) 232-6771) and give them your model number (serial is helpful too). They sent my replacement glass within a week. I have a model JED8430ABD from 2000 and they had the top. Fit perfectly and took about an hour to replace.

To change it out, after unplugging the cooktop, I removed the metal tape connecting the external vent shaft to the blower. Then I just lifted the entire cooktop out up out of the countertop so I could access the screws on the sides of the cooktop (looking at the edges of the new cooktop glass helped me figure out which screws to remove around the edge). Then I removed the 2 screws in the vent area on top (1 black screw on each side). And that released the cooktop glass from the metal box that holds the burners. I then took the rubber rings out of the knob holes so I could put them in the new cooktop (I almost missed that...). Finally, I put the new cooktop glass on, put the screws back in, lowered the cooktop back into the counter, and retaped the blower to the vent shaft. Voila!

I really wouldn't be afraid of doing this yourself if you are handy at all. And it will save you a ton. Good luck.

PS The screws around the perimeter are hexigon shapped, so you can't just use a screwdriver. I found my Black & Decker electric screwdriver had that same shaped hole that it held the bit, so I just pulled out the bit and used the screwdriver that way. Worked like a charm.

Jenn-Air JED8430... | Answered on Oct 01, 2011


We here the link for the knob of your model and also the parts diagram

Jenn-Air JED8430... | Answered on Sep 08, 2011


Hello, Thank you for your post. Sounds like your having a problem with one of the burners on your cooktop. Yes, you can have this fixed. The burner that stays on high has a bad infinite switch. Once you change out that switch your cooktop will work as normal.

Happy Holidays!
Please rate me "4 thumbs" if this information was useful.

Jenn-Air JED8430... | Answered on Aug 12, 2011


Hi,
I have found them both ways....are there wires hanging out or is it ready to be direct wired... this is often the clue to whether the BX is included or not...if you have wires then there should be BX... if not wires then they are planning on it being direct wired by your electrician...

heatman101

Jenn-Air JED8430... | Answered on Aug 05, 2011


The burner switch for that element will need to be replaced to fix this type of problem.

To replace the switch, shut off the circuit breaker to the cook top and remove it from the counter. Remove the knob from the switch that you are replacing. Remove the burner box from the cook top surface. Remove the screws that secure the burner switch. Note the location of the wires connected to the original switch. Take a digital picture if necessary. Remove the wires and replace the switch. Make sure that the wires are connected properly. Reassemble and test the cook top.

This information should help you fix this problem yourself. If you need more assistance, reply with additional details.

Jenn-Air JED8430... | Answered on Jul 27, 2011

Not finding what you are looking for?
Jenn-Air JED8430 Electric Cooktop Logo

356 questions posted

Ask a Question

Usually answered in minutes!

Top Jenn-Air Cooktops Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

MARLON KELLER

Level 2 Expert

111 Answers

Paul Carew

Level 3 Expert

3476 Answers

Are you a Jenn-Air Cooktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Jenn-Air Cooktops

  • Jenn-Air Cooktops

Most Popular Question

broken glass cook top

  • Cooktops
Loading...