Top 20
Kenneth Cole Kc1849 Touch Mens Watch - Page 9 Questions & Answers
Ingiglo does not light up what to do? can't change date either--what to do?
If your Iniglo watch is not lighting up and you are unable to change the date, there may be a problem with the battery or the watch's internal components. Here are some steps you can try to troubleshoot the issue:
- Check the battery: Make sure the battery is installed correctly and has a sufficient charge. If the battery is dead or low, try replacing it with a new one.
- Clean the contacts: Use a soft cloth to clean the battery contacts and the contact points inside the watch to ensure a good connection.
- Check the setting: Make sure the watch's backlight setting is turned on and the brightness is adjusted to a level that allows you to see the display in the current lighting conditions.
- Reset the watch: Try resetting the watch by pressing and holding the "reset" button (if your watch have) for a few seconds.
- Check for water damage: If the watch has been exposed to water, it could cause damage to the electronic components. If water has entered the watch, it is best to take it to a professional watch repair center for service.
- Check if the watch have a warranty: If the watch is still under warranty, you should contact the manufacturer for service or repair.
12/4/2022 4:38:50 PM •
Watches
•
64 views • 0 helpful votes
Accutime minecraft smartwatch wont boot or take charge
The battery ran down too far. Lithium battery controllers typically lock out if the battery is discharged below 2.6 Volts per cell because trying to recharge at standard current could cause a fire. Even if you can bring the battery back above the lockout voltage using a very low charge current, it may be damaged and will need more frequent recharging.
In other words, your best bet is to replace the battery.
7/31/2022 4:30:26 AM •
Watches
•
617 views • 0 helpful votes
How do I set the time on a Fanmis sport watch/pedometer
It's simple to change the time on a Fanmis sport pedometer. To get to the "Time" setting, all you have to do is keep pressing the "Mode" button. Then, after pressing the "Set" button, change the time using the "Start/Stop" and "Reset" buttons.
Once the time has been set, you may resume recording your steps and working toward your fitness objectives. After all, if you want to keep healthy, time is of the essence!
9/17/2022 7:01:58 PM •
Watches
•
118 views • 0 helpful votes
Not finding what you are looking for?