When the compressor is replaced, the coolant must be removed, fit the compressor, bring the system down to a vacuum then refill with coolant.I would get the refrigeration guy back to check for a leak caused by a bad installation.By the way, FREON is no longer used at it causes depletion of the ozone layer.
If it is a newer model you can look for set screws on the inside of the handles. Use a small allen wrench to loosen the set screws and lift up on the handles.
SAVE UP TO $2000 on Select GE Profile Appliance Packages ... Unplug the refrigerator or turn it off at the circuit breaker for 30 seconds to reset the control. ... Try resetting the control panel by turning off power to the refrigerator briefly. ... For service, please schedule an appointment with GE Appliances Factory Service.
If you are talking F then that is too low at -10, F? is what is required.If C then the FF (whatever that means) at 40C is too hot and -20 is about right for a freezer.
I need someone to feel the top of the compressor. Is it cool, hot or too hot to keep your hand there? Usually on GE models like yours the=> WR55X11072 Main Control Boardis the problem along with the start relay, overload and run capacitor. GE Refrigerator Model GSH25JSDD SS Parts
I'm here should you have question, Thanks, Sea Breeze
The freezer controls the fresh side temp by letting the cold air through the divider. Make sure that the passage is not blocked or iced over. Also check the cooling coils to make sure they are clean.
